How do I adjust 997 headlight washer nozzle?
How do I adjust 997 headlight washer nozzle?
Author
Discussion

Bluey Green

Original Poster:

239 posts

297 months

Wednesday 21st September 2011
quotequote all
As above. When I bought the car, it was twisted the wrong way round and is impossible to move by hand. Anyone ever had to access this?

Lordglenmorangie

3,071 posts

236 months

Wednesday 21st September 2011
quotequote all
Sorry can not advise, however during last years bad winter mine froze and when defrosted I turned them on only to see then both shoot ten foot in the air. Luckily I was stationary and able to retrieve them, pushed them back on, so they are a push fit I would say. Try pulling off and refit the correct way round .

Pope

2,653 posts

278 months

Wednesday 21st September 2011
quotequote all
Switch headlamps on, get someone to press the headlamp wash button repeatedly - this will raise the jet but not eject any water - once the jet is 'up' catch hold of it and you'll see it's held in the washer jet holder by plastic retainers; prise the retainers outwards gently and remove the jet. Refit it once the correct orientation has been set.

Bill Stein

1,595 posts

240 months

Wednesday 21st September 2011
quotequote all
If these are anything like the miniture vibrators on the gen 1 cars that pop up i dont think you can alter them.