997 GT3 Stone Chips on Sill - no protection!
Discussion
My 997 Gen 1 GT3 has developed a nasty case of gravel rash on the sills, just ahead of the rear wheels but below the stone chip protection panel. After a recent trip to Europe I was cleaning tha car and there was a large stone chip which was already rusty - ie it must have been corroding under the surface due to a surface break and a further stone has knocked the top off. I have submitted a warranty claim which has been denied as its an "outside influence" ie a stone, and the handbook apparently states that there is no "chip protection" on the GT3 due to weight, and that this area should be "inspected frequently and touched in" - so they have protected themselves as regards the "not fit for purpose" design.
My plan was to paint the side and then use a protection film on the sill. However, the quote for a porsche approved repair is 2k + VAT for one side and the film is going to be around 1K for the sills fitted. Has anyone else suffered with this and know of a cost effective solution?
My plan was to paint the side and then use a protection film on the sill. However, the quote for a porsche approved repair is 2k + VAT for one side and the film is going to be around 1K for the sills fitted. Has anyone else suffered with this and know of a cost effective solution?
Pretty much all my cars have had road rash on the sills just ahead of the rear wheels, it shows it's not a garage queen lol
No need to get Porsche to paint it, as long ad its upto porsche standards it should be fine for your extended warranty - like u say manufacturers paint warranties aren't worth the paper yadda yadda
No need to get Porsche to paint it, as long ad its upto porsche standards it should be fine for your extended warranty - like u say manufacturers paint warranties aren't worth the paper yadda yadda
I just use the OPC touch up pen for the big ones on mine and some of that Turtle wax with a crayon for the smaller stuff - silly of them not to have extended the plastic film a bit, considering there is no underseal on there?
Also a bit silly that there are reported instances of "front end paint protection film applications" voiding the warranty, when they fit the stuff to the rear arches at the factory - gotta love 'em
Also a bit silly that there are reported instances of "front end paint protection film applications" voiding the warranty, when they fit the stuff to the rear arches at the factory - gotta love 'em

nsm3 said:
I just use the OPC touch up pen for the big ones on mine
Me too.. It's like cars were back in the day :-) I just have a quick look after every wash/clean and touch in the obvious stuff.. Anything not obvious will become so in time to put right with a local repair using the chip man or something.. The panels are galvanized, right..? So you're only really going to be really super concerned about anything that might have penetrated the galvanizing..? I had a scratch on my sill just behind the front wheel after only a few months (like a nail or something had gouged the outer layers of paint) and it went black in the scratch, which I assume was the zinc corrosion.. I have touched it in and I keep looking at it to see if anything is getting worse, but it doesn't seem to be..
Interestingly, this would have happend on any 997.2 as it was above the line to which they use that bouncy anti chip paint stuff..
Mine has this too. I got a quote from Chaplane in Colchester (Offical Porsche repairer), it was £640 (inc vat) per side and this included replacing the existing standard stonechip protector. I haven't had it done yet as I was worried about them matching the colour (mine is GT silver)
I think they are taking advantage of the porsche approved tag to charge a fortune. Obviously its a stack of cash hence the original post.
I think its interesting that the non-GT cars have some material applied to the sills and the RS's seem to have a plastic sill cover. This problem seems to be more limited to gen 1 GT3's, and really is a crap piece of design with a get out clause in the handbook!
I think its interesting that the non-GT cars have some material applied to the sills and the RS's seem to have a plastic sill cover. This problem seems to be more limited to gen 1 GT3's, and really is a crap piece of design with a get out clause in the handbook!
GrahamSaunders said:
I think they are taking advantage of the porsche approved tag to charge a fortune. Obviously its a stack of cash hence the original post.
I think its interesting that the non-GT cars have some material applied to the sills and the RS's seem to have a plastic sill cover. This problem seems to be more limited to gen 1 GT3's, and really is a crap piece of design with a get out clause in the handbook!
so is does the GT3 has smooth sills rather than "shultz" type paint then?I think its interesting that the non-GT cars have some material applied to the sills and the RS's seem to have a plastic sill cover. This problem seems to be more limited to gen 1 GT3's, and really is a crap piece of design with a get out clause in the handbook!
Gassing Station | Porsche General | Top of Page | What's New | My Stuff


