Engineered Wooden Flooring in Bathroom
Discussion
We're thinking of putting a wooden floor in our fairly large family bathroom. It has a big walk in shower and a cast iron bath (which won't be used much) so I'm thinking there shouldn't be huge amounts of water on the floor.
It would be lacquered oak engineered flooring and I'm looking at a product that has a click system which should pull the joints tight. In addition I'd glue every joint with wood glue - the floor would otherwise be floating. In theory this should leave a fully sealed surface but I've read and seen a few horror stories with wood in wet areas.
Anyone any experience?
It would be lacquered oak engineered flooring and I'm looking at a product that has a click system which should pull the joints tight. In addition I'd glue every joint with wood glue - the floor would otherwise be floating. In theory this should leave a fully sealed surface but I've read and seen a few horror stories with wood in wet areas.
Anyone any experience?
Personally i'd be very nervous. When we had our wood floor installed the fitter told me that that you need to clean up any liquid spillages straight away. No matter how hard you try you will always get water on a bathroom floor and will everybody in your house be careful about cleaning it up? As well as the spillage issue, bathrooms are also very damp rooms (even if you have good ventilation.
The other issue is that I imagine that the wood the wood would become very slippery when wet.
The other issue is that I imagine that the wood the wood would become very slippery when wet.
I put some cheaper grade laminate in our kitchen as i know it was going to get some use and abuse of thru traffic to rest of house,
however i applied four layers of industrial floor sealer and buffed it up,
this stuff seals and hardens, doing the job so far,
cant see why a good yacht varnish would not seal also
obviously not edges.
however i applied four layers of industrial floor sealer and buffed it up,
this stuff seals and hardens, doing the job so far,
cant see why a good yacht varnish would not seal also
obviously not edges.
Inkyfingers said:
I'd have thought solid wood would be better than engineered wood.
No it wouldnt, solid wood, particularly Oak, could be a nightmare in a bathroom, engineered is more stable but I wouldnt use either in a bathroom.Its not just water on the floor you have to worry about, the moisture & condensation in a bathroom could give you serious problems.
I sell a lot of flooring every month (see link on my profile) & I wouldnt put it in my bathroom.
Nick

I think wood products should be avoided in wet rooms as wood does not like water. Engineered is better than solid but I would still avoid it.
The previous owner of my house fitted wood flooring everywhere downstairs, including the utility room. The washing machine leaked and the floor is buckled to hell now. It buckled so much that it started to lift the stud wall between this room and the kitchen and has created a 8mm gap the bottom of the wall - probably doesn't help that the bottom plate of the wall wasn't screwed down.
The previous owner of my house fitted wood flooring everywhere downstairs, including the utility room. The washing machine leaked and the floor is buckled to hell now. It buckled so much that it started to lift the stud wall between this room and the kitchen and has created a 8mm gap the bottom of the wall - probably doesn't help that the bottom plate of the wall wasn't screwed down.
Don't use engineered oak floors in a bathroom the water vapour and hmidity will cause major problems.
In the very recent years I have refitted four bathrooms and I used marine ply over the existing floor ( screwed down at 4 inch centres into the wooden floor) with either vinyl planks ( which do a great job in the bathroom environment) or the "floor in a box" from Tarkett which B&Q used to stock.
IMHO the Tarkett stuff is absolutely fantastic and knocks the standard planks into a hat for appearance, durability and adhesion. Put this stuff down and nothing will get it to come unstuck. Dead easy to lay as well. ( I only tried it cos it was cheaper on special offer than the planks).
hth
Cheers,
Tony
In the very recent years I have refitted four bathrooms and I used marine ply over the existing floor ( screwed down at 4 inch centres into the wooden floor) with either vinyl planks ( which do a great job in the bathroom environment) or the "floor in a box" from Tarkett which B&Q used to stock.
IMHO the Tarkett stuff is absolutely fantastic and knocks the standard planks into a hat for appearance, durability and adhesion. Put this stuff down and nothing will get it to come unstuck. Dead easy to lay as well. ( I only tried it cos it was cheaper on special offer than the planks).
hth
Cheers,
Tony
A related question, anyone have any thoughts on laminate/engineered wood in kitchens?
We're buying a new build and looking at flooring options, house builder offers Pergo but going to get an external quote too. This would be for entrance hall, downstairs loo, kitchen and utility. Would tiles be better? I much prefer the wood look.
Cheers.
We're buying a new build and looking at flooring options, house builder offers Pergo but going to get an external quote too. This would be for entrance hall, downstairs loo, kitchen and utility. Would tiles be better? I much prefer the wood look.
Cheers.
Shouldnt be a problem in a kitchen as the moisture level in the air is much lower than a bathroom, but go for an engineered board rather than solid as it tends to be more stable. (If a little more expensive).
One tip, if water gets spilt clean it up immediatly, & dont clean the floor with a wet mop, use the specialist cleaning kit & dry floor mop with wipes & all will be well.
Nick
One tip, if water gets spilt clean it up immediatly, & dont clean the floor with a wet mop, use the specialist cleaning kit & dry floor mop with wipes & all will be well.
Nick

As this thread seems to have concluded may I just get everyone's attention and ask for a recommendation for brand and supplier of engineered oak flooring? It's to go in our hall. I don't want to spend too much but I also don't want rubbish.
I think I've seen Kahrs mentioned, is this a good option or am I paying too much?
I think I've seen Kahrs mentioned, is this a good option or am I paying too much?
We've been looking at a brand called Elka for engineered oak. Mainly as they do a structural board that can go right onto the joists which is good for areas where we have underfloor heating. I've only got 1 pack as a sample but it does look very good. They do thinner boards that can be used as a floating floor.
ncs said:
No it wouldnt, solid wood, particularly Oak, could be a nightmare in a bathroom, engineered is more stable but I wouldnt use either in a bathroom.
Its not just water on the floor you have to worry about, the moisture & condensation in a bathroom could give you serious problems.
I sell a lot of flooring every month (see link on my profile) & I wouldnt put it in my bathroom.
Nick
(Sory about the HJ chaps).Its not just water on the floor you have to worry about, the moisture & condensation in a bathroom could give you serious problems.
I sell a lot of flooring every month (see link on my profile) & I wouldnt put it in my bathroom.
Nick

Nick
We have got to do a 16ft x 12ft lounge shortly. The remit is that is must look like Oak planks, resist our kids' attempts at destroying it with orange squash spills, our dog's claws, heavy furniture and it must look good.
It's going down on a screed floor.
Should we go solid oak, engineered, Karndean?
What would you recommend?
Manks said:
(Sory about the HJ chaps).
Nick
We have got to do a 16ft x 12ft lounge shortly. The remit is that is must look like Oak planks, resist our kids' attempts at destroying it with orange squash spills, our dog's claws, heavy furniture and it must look good.
It's going down on a screed floor.
Should we go solid oak, engineered, Karndean?
What would you recommend?
We are having solid oiled oak, and have an active 4 year old and a dog!Nick
We have got to do a 16ft x 12ft lounge shortly. The remit is that is must look like Oak planks, resist our kids' attempts at destroying it with orange squash spills, our dog's claws, heavy furniture and it must look good.
It's going down on a screed floor.
Should we go solid oak, engineered, Karndean?
What would you recommend?
Gassing Station | Homes, Gardens and DIY | Top of Page | What's New | My Stuff



h to keep clean but look great.