Clutch Question
Discussion
Sitting at the lights tonight in gear and foot on brake pedel suddenly thought should i be doing this as it's a manual car.
When im in a auto car i don't take it out of gear or put the hanbrake on when staionary and im driving this car in the same manner am i wearing the clutch out?
Sportshift model.
Thanks
When im in a auto car i don't take it out of gear or put the hanbrake on when staionary and im driving this car in the same manner am i wearing the clutch out?
Sportshift model.
Thanks
This is what it says:
On any ASM Aston(Vanquish to present VH platform), it is best(and recommended) to put the vehicle in neutral when stationary for a period of time, yes this will prolong the life of the clutch and release bearing.
A large percentage of clutchs that I change are from clients of ASM vehicles because of this whole not putting in neutral and sitting stationary with trans in 1st gear. It would be the same as sitting at the light in a regular manual car with the clutch pushed to the floor..the friction disc would spin on the input shaft and slip between the pressure plate and flywheel, there is nothing to actually keep the friction disc from making contact..the pressure plate is lifted away from the friction disc, but nothing brings the friction disc away from the flywheel..aka wear occurs.
When in neutral the clutch is engaged and spining with the engine, so no slipping is down.
Also the release bearing, even though it's hydraulic still faults from wear-and-tear, then a leak happens and saturates the friction disc..at this point everything needs to be replaced.
I must be honest I didn't really understand how it worked before reading that but will be making sure I put it into N always when possible.
On any ASM Aston(Vanquish to present VH platform), it is best(and recommended) to put the vehicle in neutral when stationary for a period of time, yes this will prolong the life of the clutch and release bearing.
A large percentage of clutchs that I change are from clients of ASM vehicles because of this whole not putting in neutral and sitting stationary with trans in 1st gear. It would be the same as sitting at the light in a regular manual car with the clutch pushed to the floor..the friction disc would spin on the input shaft and slip between the pressure plate and flywheel, there is nothing to actually keep the friction disc from making contact..the pressure plate is lifted away from the friction disc, but nothing brings the friction disc away from the flywheel..aka wear occurs.
When in neutral the clutch is engaged and spining with the engine, so no slipping is down.
Also the release bearing, even though it's hydraulic still faults from wear-and-tear, then a leak happens and saturates the friction disc..at this point everything needs to be replaced.
I must be honest I didn't really understand how it worked before reading that but will be making sure I put it into N always when possible.
Good to know...
Although never mind mechanical sympathy for your car, spare a thought for the poor sods stopped behind you that are being dazzled by your brake lights.
Accordingly, handbrake/neutral should be the default driving technique if you expect to be at a halt for more than ten seconds, manual or auto! :-p
Although never mind mechanical sympathy for your car, spare a thought for the poor sods stopped behind you that are being dazzled by your brake lights.
Accordingly, handbrake/neutral should be the default driving technique if you expect to be at a halt for more than ten seconds, manual or auto! :-p
Gassing Station | Aston Martin | Top of Page | What's New | My Stuff


