New Bits - advice
Discussion
snorky said:Not much to go on, http://ourworld.compuserve.com/homepages/Peter_Beech/TVR/parts.htm but I felt sorry for you as nobody had replied! Good luck!
I want to change the following bits on the Chim...any advice as to part nos or suppliers please
Coil (Bosch better ? )
Rotor arm
Dist Cap
Volt regulator/amplifier thingy next to coil
Ta Muchly
here's my penny's worth
Coil -Bosch is best, mine being changed tomorrow, some of the codes given on the forums and the link are wrong!! If someone doesn't beat me to it I'll post tomorrow. PS the Bosch number is a 12 digit figure if I recall
Rotor arm - is Lucas; got mine from Tim @ Act at a competitive price
Dist Cap - got mine from Tim @ Act at a competitive price
Volt regulator/amplifier thingy next to coil - I have a code of Lucas DAB135 or Intermotor PRC6574
If your looking at leads or plug extenders I would recommend Act again. Bosch leads were quoted at £150 per set
and Bosch plug extenders with the suppressor at £15 each
whereas the Act kit was very competitive in comparison (approx £70 and £3.20 + vat respectively) also you know it will work because they are specialists!
And before anyone asks; I am in no way connected with Act Products but impressed with their service (and I have only just started using them)
Hope this helps
Coil -Bosch is best, mine being changed tomorrow, some of the codes given on the forums and the link are wrong!! If someone doesn't beat me to it I'll post tomorrow. PS the Bosch number is a 12 digit figure if I recall
Rotor arm - is Lucas; got mine from Tim @ Act at a competitive price
Dist Cap - got mine from Tim @ Act at a competitive price
Volt regulator/amplifier thingy next to coil - I have a code of Lucas DAB135 or Intermotor PRC6574
If your looking at leads or plug extenders I would recommend Act again. Bosch leads were quoted at £150 per set
and Bosch plug extenders with the suppressor at £15 each
whereas the Act kit was very competitive in comparison (approx £70 and £3.20 + vat respectively) also you know it will work because they are specialists! And before anyone asks; I am in no way connected with Act Products but impressed with their service (and I have only just started using them)
Hope this helps
Well; changed leads, plugs, coil, rotor arm, dizzy cap, plug extenders, reset ECU and cleaned the stepper motor. Result is a super smooth motor again.
but tick over is still hunting; hoping it will steady when ECU settles in again!!
For interests sake and as I promised:
BOSCH COIL PART NO is 0 221 122 392
Only other problem is that the temp gauge is making major movements now; any help gratefully accepted, will go searching later tonight on the forums but don't recall anything from previous searches
but tick over is still hunting; hoping it will steady when ECU settles in again!! For interests sake and as I promised:
BOSCH COIL PART NO is 0 221 122 392
Only other problem is that the temp gauge is making major movements now; any help gratefully accepted, will go searching later tonight on the forums but don't recall anything from previous searches
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


