WANTED. 16" wheels for my 350i

[P3trolhead]

Anybody got some for sale? Or can you guys point me in the right direction of where to buy some. All help is much appreciated for this noob

Steve

[Solitude]

What kind ?

Lattice alloys as standard for a 350 are 15" (i think)

Gavin

[P3trolhead]

I have the STD lattice, just want another set so I can put r888 on and keep for dry sunny days. Would like the 16" just to give a different look.

[P3trolhead]

Or a set of 15" that are not lattice. Thanks

[Gandalf]

Would a brand new set of these be of interest?




As specc`ed by TVR for the Speed 8

[P3trolhead]

They look perfect! How much?

[350zwelgje]

P3trolhead said:

They look perfect! How much?

If you don't buy them, could be that I am interested.....
Due to the Speed8 being my favorite TVR prototype (sat in it in the factory and was gutted as the word came out it had been put in a skip ), and even better that they fit a standard wedge.
Once read that these existed in 15 inch, but these are then 16 as you asked for that.

Rob

[hallsie]

If you are after a cheap set, Ive got 4 16" wheels and tyres that came with my FHC.

I think they are originaly of of a nissan 200sx and are in reasonable condition, the tyres are good too.

Im in North Kent, give me a shout.

Stu

[adam quantrill]

I have a set of Cerbie alloys machined to the Wedge stud PCD.

They could do with spigot rings though to centre them properly - I machined one ring but the other three need doing.

[benebob]

Don't know if you can get VOXX wheels over there but the Voxx MG2 and MG3 are sold in a pattern and offset which fit the 280i perfectly. I think they stick out an extra couple mm from stock.


http://www.voxxwheel.com/eng/wheels/euro-style/mg-...

[TVRleigh_BBWR]

Talking about 16" wheel,

Did they do any OZ wheel 16" but by 8" or 8.5" (The Tuscan racer ones was 9") plus if anyone has any do they want to swap for 9" ones.

Or does anyone know if the 9" ones can be fitted with a narrower rim.