Flat Roof - easy DIY job?
Author
Discussion

Tiggsy

Original Poster:

10,261 posts

283 months

Friday 4th November 2011
quotequote all
I have a 30 year old flat roof over my utility room - prob 3X4m

I leaked a couple of years ago so I slapped a new bit of felt over the leaky bit and sealed it down. A few weeks ago it started leaking again and (despite slapping down more felt/gunky stuff) its now leaking like mad....bucket every 3 hrs!

The roof is felt ontop of strawboard stuff (which is, being straw!, soaked) and falling apart!

I assume the job is - rip up old roof, rip out soggy under board - I assume this will expose timbers that sit above the plasterboard roof of the room below?

Lay new baord, lay new felt (dont want fancy roof with big costs as it will all be ripped out within 5 years when we extend)

So - is it a job that I can get done under £1k?

And, if not, is it a job I can do myself?

And - will it ever stop bloody raining!

dickymint

29,250 posts

289 months

Friday 4th November 2011
quotequote all
There was a thread the other month where one guy used this stuff.......

http://www.rubba-seal.co.uk/how+it+can+work+for+yo...
Looks good to me.

Found the thread....

http://www.pistonheads.com/gassing/topic.asp?h=0&a...

Tiggsy

Original Poster:

10,261 posts

283 months

Friday 4th November 2011
quotequote all
cool - looks easy enough - think i'll cover the whole roof in tarpuline till spring then attack it when the weather perks up.

Dont fancy stripping the roof in Nov only to have the heavens open!

shimmey69

1,525 posts

209 months

Saturday 5th November 2011
quotequote all
A small flat roof like that will easily come in under a £1000 it's a days work for a good builder/roofer to do.

Where about in the south east are you??

mart77

250 posts

211 months

Saturday 5th November 2011
quotequote all
you could easily do it under 1k.it needs the roof stripping off.some decent ply putting back on then put the new felt on using a flame.could easily be done in one day for around 700 to 800 imo

roofer

5,136 posts

242 months

Saturday 5th November 2011
quotequote all
Sounds like you have Stramit board on there. There is a possibility it has an Asbestos content paper on one side.

It can also give way underneath you with little warning, despite feeling ok. It is a days work for a professional, but if you want to try and extend its life till the spring, put a coat or two of Acropol over it.

Tiggsy

Original Poster:

10,261 posts

283 months

Saturday 5th November 2011
quotequote all
I'm in Reading - so prob not worth doing DIY then? I worked it out at £300 ish in parts but if the labours is only a few hundread on top...?

roofer

5,136 posts

242 months

Saturday 5th November 2011
quotequote all
'Parts'

3 rolls HT Mineral £85.00
1 Roll HT underlay (16m) £30.00
3 sheets 18mm WBP £60.00
Sundries £20.00

Try local SIG roofing supplies.

Add £50.00 for regional variation and put vat on as well. Stripping the stramit which is approx 2" thick will leave a check around the perimeter because the ply is only 18mm. Easiest way to overcome is put a 2x2 on your frame before the ply to lift it up, or you will have to cut fascia down.