Help needed...

[maverick25]

Not sure if anyone can help but here goes:

I want to install my ITG induction kit and according to the detailed intructions on Hanger 111 it all looks pretty straight forward EXCEPT whilst having a good root around I noticed another box atatched to the current air box. I understand this is the resonator box(to reduce the intake noise by the air intake system).

There is no obvious way to remove this at the moment and it looks as though i'll have to remove the wheel arch cover to get in there.

is this something I can do myself with limited knowlege, but willing to learn, or do I have to part with the best part of £150 to get it fitted by a garage?

Answers on a postcard,
Thanks in advance...

[steff]

Unless you are an olympic gymnast its easier to fit the ITG by removing the rear wheel arch liner.

Jack up the car on the passenger side (using the correct jacking point!) remove the rear wheel and wheel arch liner, you will now be able you get at the two bolts that are holding the intake box in place.

When you remove the wheel arch liner there is a speed sensor on the hub unclip at the hub end and cut off the two cable ties holding the cable to the top wishbone and push the gromit through the liner.

[maverick25]

Help from a fellow welshman! Many thanks, I'll have a go!

[steff]

Dim problemo!