RIde height

[dbv8]

Where exactly do we measure from.
My Chim was bottoming out a lot last week with a boot full of stuff.

The boot has been emptied apart from the essentials and ive just measured from ground to corners of outriggers,
Rear = 135mm
Front = 140mm

I guess the rear of my car must have 'settled' some since the geo set up last Summer.

I am on Nitrons and have my C spanner at the ready.

Recommendations?

Edited by dbv8 on Friday 2nd March 12:35

[dbv8]

Peter.... anybody?

[clive f]

from memory on my griff I always used to have the rear 12 to 15mm higher than the front, can`t remember the measurements, but 2 fingers between top of tyre and wheelarch should be plenty.(depends on how hard/soft you like it)

[Goaty Bill]

I asked the same question a while back;

Ride Height and chasis travel

I am about 25mm lower than 'standard' on the cheap protechs.
Of all the people on here, I probably shouldn't have to ask this of you , but did you up the tyre pressure when you loaded up?
Makes a huge difference to mine if the pressure is changed by 2psi.

[Alexdaredevilz]

Try the 'Atkins'

That should raise the car

[Ant.]

Rear should be about 15mm higher than front.