Oil pressure gauge
Discussion
My Chim has been sitting for a few months and during that time was getting some electrical work done.
I have started it this evening and I left it running for 5 mins or so. I then noticed that the oil pressure gauge was not off the bottom (probably should have noticed that earlier).
I have checked the oil level and it is fine. I took the oil cap off and got a slight puff of smoke (nothing major).
Just looking for some guidance. I presume that as the oil level is OK that I don't have a problem - It is more likely that the gauge has been disconnected / fused or something electrical?
Cheers
Aidan
I have started it this evening and I left it running for 5 mins or so. I then noticed that the oil pressure gauge was not off the bottom (probably should have noticed that earlier).
I have checked the oil level and it is fine. I took the oil cap off and got a slight puff of smoke (nothing major).
Just looking for some guidance. I presume that as the oil level is OK that I don't have a problem - It is more likely that the gauge has been disconnected / fused or something electrical?
Cheers
Aidan
aidanbree said:
no warning lights at all
What electrical work was you having done?
personally I would not drive it till your sure you have got some pressure otherwise this could end it tears better to be safe than sorry and all that.......
RV8 tappets are slow bleeders so I would not gauge the fact they are not noisy as to whether you have oil pressure or not 
Edited by Simon says on Wednesday 21st March 22:52
Gassing Station | Chimaera | Top of Page | What's New | My Stuff




