fitting new indicator stalks

[PYNEY]

hi all

next job is to fit a shiny pair of indicator stalks ?

being a carpenter i thought easy job just cut the old ones off and fit the new ones easy ?
took a look at it today read the fitting instruction but i cant make out where to cut the old stalks
i'm only going to get one chance at this so has anyone done this and where do you make the cut ?

photo would be good

cheers keith

[slideways]

piece of cake mate, just cut the stalk just after where it starts to splay out at the webs IYSWIM file the webs flat and screw the new shiny stalks on

[PYNEY]

thanks for the info , thats where i was thinking of cutting it , but it looks to small
at this point , the end of my stalks where the grub screw is looks like a larger diameter even with the grub screw
to pull it up tight ?
i'll have to try and measure the old stalk at this point and check it will fit

[slideways]

PYNEY said:

thanks for the info , thats where i was thinking of cutting it , but it looks to small
at this point , the end of my stalks where the grub screw is looks like a larger diameter even with the grub screw
to pull it up tight ?
i'll have to try and measure the old stalk at this point and check it will fit

the hole is larger you should have 4 grub screws to centre the stalk

[PYNEY]

i'll check in the morning but i'm sure i only have 1 grub screw to pull it in

cheers keith