Wheel alignment
Discussion
Should be this (as it it my current setting):
Front:
Camber -1 degrees (plus-minus 0,5)
Castor -3,5 degrees (plus-minus 0,5)
Toe 0,5 degrees
If this is not ok, I would like to know as well!
And would like to know what the toe at the rear should be. I have a note that says 0 to 3,3 mm, and thought that that had to be in degrees as well.
To be complete, camber rear should be the same as at the front.
Perhaps an idea for Steve to include this in the next release of the Wedge Bible? Or in a FAQ corner of the Wedgepages (Mike?)
Rob (350i, series II)
>> Edited by 350zwelgje on Friday 23 July 21:27
Front:
Camber -1 degrees (plus-minus 0,5)
Castor -3,5 degrees (plus-minus 0,5)
Toe 0,5 degrees
If this is not ok, I would like to know as well!
And would like to know what the toe at the rear should be. I have a note that says 0 to 3,3 mm, and thought that that had to be in degrees as well.
To be complete, camber rear should be the same as at the front.
Perhaps an idea for Steve to include this in the next release of the Wedge Bible? Or in a FAQ corner of the Wedgepages (Mike?)
Rob (350i, series II)
>> Edited by 350zwelgje on Friday 23 July 21:27
Gassing Station | Wedges | Top of Page | What's New | My Stuff