Best garage floor paint ? Best way to do it
Discussion
So having seen some of the fantastic garages on here it has moved me to do something about the floor in mine ( currently concrete. I want to paint it to seal it and then tile half of it ( plastic tiles) so what is the best paint to use and what is the best method ? Roller brush etc
Garage is circa 80m2
Thanks
Phib
Garage is circa 80m2
Thanks
Phib
The most important thing to get right is the preparation of the concrete floor before painting. My method is as follows:-
1. Sweep floor.
2. Vacuum clean floor (yes, 'hoover' it).
3. Wash floor - mild detergent.
4. Allow floor to dry.
5. Seal floor with proprietary sealant (available at DIY stores).
6. Paint floor (lots of proprietary floor paints available) - roller is OK for 'mass' coverage but will need to fill in with brush where necessary.
Have done 2 garage floors like this with good results but wet car tyres eventually lift the paint where the car is parked so tiles are a good idea.
1. Sweep floor.
2. Vacuum clean floor (yes, 'hoover' it).
3. Wash floor - mild detergent.
4. Allow floor to dry.
5. Seal floor with proprietary sealant (available at DIY stores).
6. Paint floor (lots of proprietary floor paints available) - roller is OK for 'mass' coverage but will need to fill in with brush where necessary.
Have done 2 garage floors like this with good results but wet car tyres eventually lift the paint where the car is parked so tiles are a good idea.
Sweep out the worst of the dust, give it a vac, seal with pva/water or garage floor sealer (roller it on), once dry roller on some garage floor paint.
I used International stuff (well that's a lie, I did the first bit (sealed with International stuff) and then decided to put down floor tiles!
In fact, if you are local to me and want to buy a cheap can of grey International floor paint, drop me a message
I used International stuff (well that's a lie, I did the first bit (sealed with International stuff) and then decided to put down floor tiles!
In fact, if you are local to me and want to buy a cheap can of grey International floor paint, drop me a message

As above, but. You can seal it with a mix of PVA glue and water 50/50. However, if you want a bullet proof floor, one you can drag an engine across and not damage it, it got to be epoxy sealed. Probably the best know is WATCO. http://www.watco.co.uk/ If you happen to have a contact in the building trade, you'll probably be able to get it a bit cheaper, or someone who works in a maintenance department of a building.
Gassing Station | General Gassing | Top of Page | What's New | My Stuff



