Door / Window ecu, fixable?
Discussion
After a bad week in the garage today just about tops it off. I've spent the last couple of weeks and precious hours in the garage getting the ls conversion done, bleeding the clutch, to find a pool of fluid under the car. Gearbox out!!
Thought I'd start on the electrics, I know they would be ok as it was all working when the car was stripped down. Wishful thinking!! It was going too well when I accidently put in the plugs on the door window ecu in the wrong position, fuse popped and now the boot solenoid pulses continually when the power is connected. I damaged one of the tracks on the printed circuit board, fixed that but don't know which component is damaged and would cause the fault. Have seen a thread on here where some one had the same problem but can't find it now. If i can fix it without sending it away then that would be fantastic. Any info would be appreciated.
Regards Simon
Thought I'd start on the electrics, I know they would be ok as it was all working when the car was stripped down. Wishful thinking!! It was going too well when I accidently put in the plugs on the door window ecu in the wrong position, fuse popped and now the boot solenoid pulses continually when the power is connected. I damaged one of the tracks on the printed circuit board, fixed that but don't know which component is damaged and would cause the fault. Have seen a thread on here where some one had the same problem but can't find it now. If i can fix it without sending it away then that would be fantastic. Any info would be appreciated.
Regards Simon
Sorry G20v6... I need to point you in the direction of pselectronicsolutions.co.uk as they (Paul Smith) sorted my electric boxes within a week. £40 each. Don't fart about like I did for ages trying to sort them... send it off asap and have it back guaranteed working!!
Edited by K33LER on Tuesday 15th May 23:36
Gassing Station | Cerbera | Top of Page | What's New | My Stuff