X5 Rear Wheel Camber
Discussion
I have a 2006 (56 plate) X5, and have just had to change the tyres due to wear on the inside of both rear tyres.
The outside of the tyres still had massive amounts of tread on them, it was only the inside 1/5th of the tyre which was badly worn.
The tyres are Bridgestone Duellers and have been on there for about 2 years, about 20k miles.
I've always noted that the car ran with a lot of negative camber on the rears, but that has been the case since new, and the previous set of tyres had a more even wear pattern over the width of the tyre.
My obvious thought is that the negative camber has caused the damage, but I'm wondering if there might be something else that needs checking?
Appreciate any advice!
The outside of the tyres still had massive amounts of tread on them, it was only the inside 1/5th of the tyre which was badly worn.
The tyres are Bridgestone Duellers and have been on there for about 2 years, about 20k miles.
I've always noted that the car ran with a lot of negative camber on the rears, but that has been the case since new, and the previous set of tyres had a more even wear pattern over the width of the tyre.
My obvious thought is that the negative camber has caused the damage, but I'm wondering if there might be something else that needs checking?
Appreciate any advice!
It is not the camber that will cause the inner tyre wear but incorrectly set rear toe.
You need to carefully check the rear subframe mounting bushes, usually shot from around 40,000m and replace as necessary. Then have a full KDS wheel alignment done and this will make sure all your settings are within spec, including rear toe and camber, both of which are adjustable.
I wouls also add 20,000m is very acceptable for rear tyres on an X5 regardless of engine choice.
You may also want to try dumping the run-flats if fitted because the excessively stiff sidewalls will exacerpate the wear. try standard replacements, they are quieter, grippier, can be repaired if punctured and are half the price.
You need to carefully check the rear subframe mounting bushes, usually shot from around 40,000m and replace as necessary. Then have a full KDS wheel alignment done and this will make sure all your settings are within spec, including rear toe and camber, both of which are adjustable.
I wouls also add 20,000m is very acceptable for rear tyres on an X5 regardless of engine choice.
You may also want to try dumping the run-flats if fitted because the excessively stiff sidewalls will exacerpate the wear. try standard replacements, they are quieter, grippier, can be repaired if punctured and are half the price.
Gassing Station | BMW General | Top of Page | What's New | My Stuff


