Cooling Pipes/Hoses Replaced - Does this Look Right?
Cooling Pipes/Hoses Replaced - Does this Look Right?
Author
Discussion

yosini

Original Poster:

265 posts

173 months

Thursday 21st June 2012
quotequote all
Hi,

I think I put everything back in correctly - but before I tighten it all up and refill could someone just glance over the attached and tell me if it looks right? My only real doubt, is potentially fundamental, do both main hoses going down from the engine go into the same S/S pipe (labelled 1)? and the hose that goes to the bottom of the engine connects into the radiator pipe (labelled 2).


Whilst doing this job I must admit to being pretty impressed by the original powder coating - the majority of it was still very much there after 12 years, it's pretty well protected in there but even so. Hope it's even half that good underneath....somehow I doubt it...

Cheers

Joe

Joe

yosini

Original Poster:

265 posts

173 months

Thursday 21st June 2012
quotequote all
I hope my pipe connecting is better than my maths - a '96 Cerb makes it 16 years old...I need a beer.

pmessling

2,313 posts

227 months

Thursday 21st June 2012
quotequote all
Looks good to me, will be doing this myself in a few days.

Tanguero

4,535 posts

225 months

Thursday 21st June 2012
quotequote all
Yes - that is right - at least according to the diagram I made when I took mine off.