New brake pads ?
Discussion
KarlFranz said:
Once the sacrificial pad wear sensors start making contact with the disc surface, you will get a warning—at which point you will also need to replace the sensors in addition to the pads.
Isn't the sensor just a wire that is embedded in the pad, which then wears thru when the pads are too thin? If so, then the 'sensor' is already part of the pad, no?DB9VolanteDriver said:
Isn't the sensor just a wire that is embedded in the pad, which then wears thru when the pads are too thin? If so, then the 'sensor' is already part of the pad, no?
In a word: No. 
The wear sensor is at the end of a cable and it clips into a slot on the outboard brake pad. There is no wire in the pad itself.
If you look at my thread here I think I have a picture of it somewhere:
http://www.6speedonline.com/forums/aston-martin/24...
Edited by KarlFranz on Monday 16th July 22:18
KarlFranz said:
Once the sacrificial pad wear sensors start making contact with the disc surface, you will get a warning—at which point you will also need to replace the sensors in addition to the pads.
+1At the last service they replaced my rears at just over 3mm if I recall correctly.
The Dealer said there was no need to renew the sensors as they had not yet been 'activated'

Gassing Station | Aston Martin | Top of Page | What's New | My Stuff


