E46 - Prop Swap 328 / 330
E46 - Prop Swap 328 / 330
Author
Discussion

buggalugs

Original Poster:

9,296 posts

268 months

Friday 27th July 2012
quotequote all
Hi,

I've got a replacement diff for the noisy & leaky one in my 328i. It's a 2.93 ratio, against 3.15 I think I already have so should just be a fraction longer on the gears - perfect.

Only problem is it's got the 6 bolt input flange. I know the output flanges just pop in & out but the input flange is a bit more involved to swap as I understand, as the nut sets the preload on the bearing which is a bit of a science to get right.

I read that when taking it off to change the seal you just put a dab of paint on the nut and put it back in the same position but I don't think that will help me because I'm not putting the same input flange back on, new one will not be exactly the same length as the old.

Soooo... to get to the point can I put a 330i 5-speed prop on my 328i? I read the 328 prop is about 15mm longer, but they have an adjustment for length right? Can anyone think of a reason why this definitely wouldn't work?

Thanks!

buggalugs

Original Poster:

9,296 posts

268 months

Saturday 28th July 2012
quotequote all
Looking at things actually it seems that the bit with the diff flange is also the bit with both UJ's, and will probs be the same length across all engines as it just goes back to the centre bearing. I'm guessing the front part is the bit that varies in length depending on gearbox etc. So I guess I could get the prop to match my diff and just use the back half of it... unless there are balance issues...