Discussion
just bought a pair of these bad boys to fit on the cerb
should hopefully give it a much nicer deeper tone.
gonna fit them in place of the decat pipes after a bit of modding, just casnt stand the racket any longer lol
£90 the pair brand new, and theyll make them to whatever size you wish
....anyone else fitted the cherrybombs?
should hopefully give it a much nicer deeper tone.
gonna fit them in place of the decat pipes after a bit of modding, just casnt stand the racket any longer lol
£90 the pair brand new, and theyll make them to whatever size you wish
....anyone else fitted the cherrybombs?Edited by pulsarboby on Wednesday 1st August 18:06
Mr Cerbera said:
Will be very interested in how you roll those ends to make Male/Female mating surfaces 
p.s. Perforated Eardrums are recoverable
ETA
Just remember where I'd seen those before.
My first Mrs. bought one that was mains operated....
the decats (already fitted) will have ends cut off and il slip the pipe inside these with the rolled part already there from decat. then just weld the pipe to cherrybombs.p.s. Perforated Eardrums are recoverable
ETA
Just remember where I'd seen those before.
My first Mrs. bought one that was mains operated....
not seen a mains operated one only rechargable cordless
pulsarboby said:
.... and il slip the pipe inside these with the rolled part already there from decat. then just weld the pipe to cherrybombs.
not seen a mains operated one only rechargable cordless
Ooh, are they the same diameter ?? - Lucky Boy !!not seen a mains operated one only rechargable cordless
Can you Vid the exhaust after it's all refitted and post it - Would be very interested to hear what it sounds like
(Don't you remember when the entire Midlands was left without a single volt between them ??)
yeah il have car in workshop next week so will take a before and after vid of how these sound once fitted. ordered 2i/4' id silencers so pipes from existing should in theory slot inside these.
gotta say ive never heard a cerb as loud as this one, bloody things deafening especially on motorway
gotta say ive never heard a cerb as loud as this one, bloody things deafening especially on motorway
Edited by pulsarboby on Thursday 2nd August 16:32
yep il put a vi up a little later this week but it doesnt really tell you a lot at idle but youll get the gist of it.
im still running the nw engine in at the moment so dont want to open her up past 4k, its only done 400 miles lol
but have to say that throttle response low down has improved, much more responsive and generally easier to drive in traffic.
when you look at the decat pipes they are a fairly small bore but with the 4'' cherry bombs fitted the id of the pipe has opened so maybe this is allowing better breahing without compromising back pressure.
ive also noticed that temps in the cockpit have decreased significantly due to the thicker wall of the cherry bombs compared to the thin allie decats.
il report back on power once ive run her in and got some fully synthetic oil in her
im still running the nw engine in at the moment so dont want to open her up past 4k, its only done 400 miles lol
but have to say that throttle response low down has improved, much more responsive and generally easier to drive in traffic.
when you look at the decat pipes they are a fairly small bore but with the 4'' cherry bombs fitted the id of the pipe has opened so maybe this is allowing better breahing without compromising back pressure.
ive also noticed that temps in the cockpit have decreased significantly due to the thicker wall of the cherry bombs compared to the thin allie decats.
il report back on power once ive run her in and got some fully synthetic oil in her
vroom said:
Any photo's of them with the flanges welded on?
It looks like you've sleeved on one end but not the other..
Looks good and I'm interested too
no sorry didnt take any but basically i cut the flange off one end of the decat then slipped it inside the new silencer then welded it on with the clamp plate.It looks like you've sleeved on one end but not the other..
Looks good and I'm interested too
the other end i could have done the ame with but decided to sleeve it instead due to the fact that i ordered 18'' overall lengh bombs but they sent me 18'' body (2ft overall) and i couldnt be assed sending them back, otherwise you could have made them exactly the same size as decats
here you go fella
http://www.ebay.co.uk/itm/CHERRY-BOMB-TM-EXHAUST-1...
give them a bell as they will make them to whatever size you wish.
ideally you want 18'' overall lengh, then you can weld flanges to both ends and it then becomes a bolt on/off item.
whole lot will be less than a oner delivered (and no im nothing to do with company thats flogging them lol)
forgot to put the link
http://www.ebay.co.uk/itm/CHERRY-BOMB-TM-EXHAUST-1...
give them a bell as they will make them to whatever size you wish.
ideally you want 18'' overall lengh, then you can weld flanges to both ends and it then becomes a bolt on/off item.
whole lot will be less than a oner delivered (and no im nothing to do with company thats flogging them lol)
forgot to put the link
Edited by pulsarboby on Wednesday 8th August 17:37
Edited by pulsarboby on Wednesday 8th August 17:39
Gassing Station | Cerbera | Top of Page | What's New | My Stuff