How to remove tailgate panel on X3?
Discussion
Thee are screws inside the 2 molded recesses that you use to grab to close the tailgate.
On the bottom edge, either side of the latch there are 2x plastic rivets, push the centres of these then withdraw them,
There are 4 plastic poppers located on the inside of the panel below the rear screen that will release by gently pulling the panel once the above listed fixing have all been removed.
This is all IIRC.....
On the bottom edge, either side of the latch there are 2x plastic rivets, push the centres of these then withdraw them,
There are 4 plastic poppers located on the inside of the panel below the rear screen that will release by gently pulling the panel once the above listed fixing have all been removed.
This is all IIRC.....
Thanks Dev - just as you described!
Fun day stripping everything off the tailgate just to get to the number plate lights, but couldn't get to the broken wire! decided to add my own connection!
So its all working fine again.
Dont know how they manage to get 'ALL' the plastic poppers to line up when they build the car! Probably got about 50% to align!!!
Fun day stripping everything off the tailgate just to get to the number plate lights, but couldn't get to the broken wire! decided to add my own connection!
So its all working fine again.
Dont know how they manage to get 'ALL' the plastic poppers to line up when they build the car! Probably got about 50% to align!!!
I find this on-line BMW TIS site is quite useful for all manner of jobs: http://tis.spaghetticoder.org/
(You do have to search around the sections a bit sometime though)
(You do have to search around the sections a bit sometime though)
Gassing Station | BMW General | Top of Page | What's New | My Stuff


