E46 330i, clutch not disengaging hence can't change gears
E46 330i, clutch not disengaging hence can't change gears
Author
Discussion

CIS121

Original Poster:

1,273 posts

244 months

Friday 24th August 2012
quotequote all
Just happened today suddenly. The clutch wont fully disengage and that is stopping me from changing gears unless I stop and turn off the engine. Clutch still feels smooth, 80k car.

I've googled it and nothing obvious comes up, but sounds like it should be an identifiable problem.

Anyone had this problem before?

4rephill

5,171 posts

209 months

Friday 24th August 2012
quotequote all
Sounds like a fault in the clutch slave or master cylinder.

This seems to sound familiar: http://forums.bimmerforums.com/forum/showthread.ph...



There could be other causes though, take a look on here: http://tis.spaghetticoder.org/

(Here is the trouble shooting page for the clutch: http://tis.spaghetticoder.org/s/view.pl?1/00/04/60 )

AlfaSpider

231 posts

229 months

Friday 24th August 2012
quotequote all
I had the same problem with my 330d and sudden clutch faliure, turned out to be a failed spring in the clutch diaphragm. All was ok at the pedal just wouldn't disengage.

roofer

5,136 posts

242 months

Saturday 25th August 2012
quotequote all
Possible CDV issue?

CIS121

Original Poster:

1,273 posts

244 months

Tuesday 28th August 2012
quotequote all
Weird... Came back the car the following day and it's been working fine ever since. I was driving it very hard so shall avoid this for now until I can find out what caused the problem - a few internet searches say it happens with low gearbox oil level so I'll get this checked (although it's just had a major BMW service so I'd assume this would have been checked then)