E46 330i EML Problem HELP!!!
Discussion
Ok, the car went to the garage after the exhaust started blowing between down pipes and centre section. They've had the car over a week and the wife goes to pick the car up and the EML is now on. They told her it was because there was no fuel in it, so off she pops and fills up, starts the car and still the EML is on and the car has no power at all.
Unfortunately for me I work 300 miles away or else I'd be asking WTF. Any ideas what it could be? My guess is that the EML is on and its gone into limp mode? But taking an exhaust off? Possibly a connection problem on the lampda sensor?
Any advice would be great.
Unfortunately for me I work 300 miles away or else I'd be asking WTF. Any ideas what it could be? My guess is that the EML is on and its gone into limp mode? But taking an exhaust off? Possibly a connection problem on the lampda sensor?
Any advice would be great.
Quick update, there was lots of head scratching at the garage today. The initial fault was that at the joint the nut had corroded away allowing the pipes to part enough to blow. I knew it would be a drill out job with carbide drills etc hence using the garage.
They are still talking about debris being sucked in from the tank, and told the wife to use injector cleaner.
Sods law I'm away for another week so cannot have a look at there mess.
The wife thinks its getting better... Not convinced!
Another thought is if they've tried heating the area up with cutting tackle and buggered something in the area.
They are still talking about debris being sucked in from the tank, and told the wife to use injector cleaner.
Sods law I'm away for another week so cannot have a look at there mess.
The wife thinks its getting better... Not convinced!
Another thought is if they've tried heating the area up with cutting tackle and buggered something in the area.
Gassing Station | BMW General | Top of Page | What's New | My Stuff



ks