Tuscan 2 Headlight Covers
Discussion
Since the very wet drive back from Chatsworth in April one of the lens mists up when there is any dampness about. It dried out after some help with a warm air heater but when it stood out overnight in some rain last week the lens has misted up again.
I can dry it out with the heater but it tends to mist again almost immediately.
Red Spike has suggested drilling a hole in the lens to allow it to evaporate but not too keen on taking a drill to it unless someone else has experience of it with success.
Don't really want to have to take the cover off and reseal as it doesn't look like there are any holes in the sealant around the lens and probably more likely to have entered from the wheel arch area.
Have thought that possibly drilling a 1.5mm hole and then tapping in a stainless grub screw afterwards to make it look neat and then repeating on all lenses to make them look identical.
Any thoughts or alternative ideas??
I can dry it out with the heater but it tends to mist again almost immediately.
Red Spike has suggested drilling a hole in the lens to allow it to evaporate but not too keen on taking a drill to it unless someone else has experience of it with success.
Don't really want to have to take the cover off and reseal as it doesn't look like there are any holes in the sealant around the lens and probably more likely to have entered from the wheel arch area.
Have thought that possibly drilling a 1.5mm hole and then tapping in a stainless grub screw afterwards to make it look neat and then repeating on all lenses to make them look identical.
Any thoughts or alternative ideas??
Mine does this as well, I also discovered at chatsworth that the door seal leaks
I also had this problem on my chim rear light so I did the hole drilling and found it worked quite well. It didn't solve it completely but it cleared it a lot faster. Just go in with a really small bit as low down as you can.
I also had this problem on my chim rear light so I did the hole drilling and found it worked quite well. It didn't solve it completely but it cleared it a lot faster. Just go in with a really small bit as low down as you can.Thanks for the reassurances that we are in good company hehe!
It is the upper near side lens which correct me if I am wrong is a xenon projector which I assume cannot be removed from the rear without cutting it out so the plastic front lens would be the easier option if it came to removal.
It is the upper near side lens which correct me if I am wrong is a xenon projector which I assume cannot be removed from the rear without cutting it out so the plastic front lens would be the easier option if it came to removal.
Gassing Station | Tuscan | Top of Page | What's New | My Stuff




