Planet Ocean stopping, out of warranty
Discussion
HI,
Ive got a PO which I purchased in Sept 2007 which I wear occasionally. recently its stopped for no apparent reason. I give it a wind in the morning, then within an hour it will have stopped then takes a while to get it going again.
My concern is that Ive only noticed this recently as I dont wear it very much and whether or not this could be a cripping bill.
A basic google search shows that a few people have had similar issues and the purpose of this post isn't to ask what to do ( as I need to take it to an AD) but to find out if anyone else has had similar issues and whether you manged to get them fixed.
Thanks
Ive got a PO which I purchased in Sept 2007 which I wear occasionally. recently its stopped for no apparent reason. I give it a wind in the morning, then within an hour it will have stopped then takes a while to get it going again.
My concern is that Ive only noticed this recently as I dont wear it very much and whether or not this could be a cripping bill.
A basic google search shows that a few people have had similar issues and the purpose of this post isn't to ask what to do ( as I need to take it to an AD) but to find out if anyone else has had similar issues and whether you manged to get them fixed.
Thanks
It's 5 years old. Probably just needs a service.
Your AD will probably send it back to Bienne. I'd imagine Omega will charge in the £300 - £400 ball park unless it's the chronograph, which will probably be more. Someone with more recent experience with Omega may be better informed.
STS are Omega approved & may be slightly cheaper http://www.swisstimeservices.co.uk/
Alternatively, there are the independent watch repairers such as Genesis http://www.genesiswatchmaking.co.uk or Ryte Time http://www.rytetimewatchrepairs.co.uk/
Your AD will probably send it back to Bienne. I'd imagine Omega will charge in the £300 - £400 ball park unless it's the chronograph, which will probably be more. Someone with more recent experience with Omega may be better informed.
STS are Omega approved & may be slightly cheaper http://www.swisstimeservices.co.uk/
Alternatively, there are the independent watch repairers such as Genesis http://www.genesiswatchmaking.co.uk or Ryte Time http://www.rytetimewatchrepairs.co.uk/
Edited by andy tims on Monday 10th September 11:25
Obiwonkeyblokey said:
HI,
Ive got a PO which I purchased in Sept 2007 which I wear occasionally. recently its stopped for no apparent reason. I give it a wind in the morning
Thanks
How many turns of the crown do you do? For reference, you need to turn the crown a full 30-40 times for the watch to be fully wound, which should give you about 40hrs of power reserve! If you wear it on your wrist for the day, does it stop after an hour off the wrist?Ive got a PO which I purchased in Sept 2007 which I wear occasionally. recently its stopped for no apparent reason. I give it a wind in the morning
Thanks
Obiwonkeyblokey said:
yes, thats about right. I would it about 20 times as thats what the dealer advised. ( i suppose im conscious of overwnding)
I wound it more this morning and so far so good.
Modern automatic watches have clutches to prevent overwinding, and usually take around 30 to 40 full rotations of the crown to reach maximum power reserve from empty. Mechanical movements use a variety of escapement mechanisms to stop the mainspring unwinding in one big explosion, but as the mainspring unwinds, the amount of potential energy reduces and the accuracy of the movement decreases until it no longer has the power to push the escapement through another cycle. If the movement is left to wind automatically and the mainspring has only a little energy stored in it, then it will appear to run slowly and will occasionally stop, waking up with a nudge of the wrist every now and then.I wound it more this morning and so far so good.
Gassing Station | Watches | Top of Page | What's New | My Stuff



