Any BMW Techs in here? surging throttle problem e60 525d
Discussion
I have a 2004 pre-lci e60 525d which when warmed up has a fluctuation at any throttle seting like its hunting.
Took it to the local Indy who put it on their machine and as soon as they selected "smooth running test" the fluctuation disappearred!
Take it back out of the test mode and it starts fluctuating again though.
Today (and this isnt the first time this has happened) I let the car idle for about 5 mins after a good run, and then selected reverse at which point the DIS said "engine malfunction reduced power" the car spluttered and then died.
Re-started fine and ran fine (with throttle fluctuation), error codes prior to this said fuel filter - but that was replaced last week and no improvement. I havent had the error codes check yet as the garage were too busy when I went to see them.
Any ideas?- I'm wondering what sensors the "smooth running test" switches off or ignores as whetever it did it temproarily fixed the fault..
apart from glow plugs being faulty heres teh codes I got from the IM and other places via INPA
4CE0 motor protection was activated regeneration particulate filter heavily loaded test conditions are not fulfilled
TURBO PRESSURE FEEDBACK 2294.14MBAR
PRESSURE OVER particle filter 374.15
VEHICLE SPEED 92.78K/MH
4570 rail pressure too low / positive control deviation and stellgroesse too high
4560
4610 rail pressure too low / positive control deviation and electronically reversible pressure control valve too high
4587 clogged fuel filter filter
4203 glow controller
Fuel filter was replaced last week and I'm told glow controller is not a problem as its not -5
4CE0 motor protection was activated regeneration particulate filter heavily loaded test conditions are not fulfilled
TURBO PRESSURE FEEDBACK 2294.14MBAR
PRESSURE OVER particle filter 374.15
VEHICLE SPEED 92.78K/MH
4570 rail pressure too low / positive control deviation and stellgroesse too high
4560
4610 rail pressure too low / positive control deviation and electronically reversible pressure control valve too high
4587 clogged fuel filter filter
4203 glow controller
Fuel filter was replaced last week and I'm told glow controller is not a problem as its not -5
this hasn't gone away!!
Did some more digging and when it's fluctuating on the revs, the fuel
Pressure is swinging +\- 50% ie asking for 300 bar but actually getting 250 and 350
Peak to trough.
Put it into rotational conformity or selective mass and it smooths out, rail pressure stops
Fluctuating and revs are fine. Drive the car ten yards and it starts fluctuating.
Drive the car while fluctuating and then hit selective mass and it straightens out until you come out of that test.
Wtf????
I will Post a link to some videos I took of the diagnostics in action.
http://www.youtube.com/watch?v=st7VK5wLnnE&fea...
http://www.youtube.com/watch?v=bqptQKawXFw&fea...
Did some more digging and when it's fluctuating on the revs, the fuel
Pressure is swinging +\- 50% ie asking for 300 bar but actually getting 250 and 350
Peak to trough.
Put it into rotational conformity or selective mass and it smooths out, rail pressure stops
Fluctuating and revs are fine. Drive the car ten yards and it starts fluctuating.
Drive the car while fluctuating and then hit selective mass and it straightens out until you come out of that test.
Wtf????
I will Post a link to some videos I took of the diagnostics in action.
http://www.youtube.com/watch?v=st7VK5wLnnE&fea...
http://www.youtube.com/watch?v=bqptQKawXFw&fea...
Edited by hman on Wednesday 31st October 19:43
Gassing Station | BMW General | Top of Page | What's New | My Stuff


