Is this right? 335d with bad tyre wear - RFT's
Discussion
I've been getting a lot of wear on one of my front runflat tyres, which I suspected initially was most likely due to underinflation as both the inner and outer shoulders were showing a lot of wear, so looked at the cost of replacing the RFT's on their own I thought I'd also look into the cost of a set of aftermarket alloys and tyre packages to get rid of the RFT's altogether.
So I went out to check the tyre sizes. It seems the offside front and rear tyres are both 225/40/18 and the nearside front and rear tyres are both 255/35/18....
Aren't the wider tyres supposed to go on the back rather than both on one side?
Would this have made any difference to the wear on the tyres as the offside front (225/40/18) is bald as a coot on the inner and outer edge, whereas the nearside front (255/35/18) seems fine...
Both were replaced at the same time by a dealer when I bought the car.
If the tyre size makes no difference I'll carry on looking for a new tyre or wheel/tyre package. If it has made a difference I'll be putting a call in to the dealer I bought it from just over 6 months ago as they changed 3 of the 4 tyres when I bought it.
Just thought I'd ask first before making any judgement!
Cheers!
So I went out to check the tyre sizes. It seems the offside front and rear tyres are both 225/40/18 and the nearside front and rear tyres are both 255/35/18....
Aren't the wider tyres supposed to go on the back rather than both on one side?
Would this have made any difference to the wear on the tyres as the offside front (225/40/18) is bald as a coot on the inner and outer edge, whereas the nearside front (255/35/18) seems fine...
Both were replaced at the same time by a dealer when I bought the car.
If the tyre size makes no difference I'll carry on looking for a new tyre or wheel/tyre package. If it has made a difference I'll be putting a call in to the dealer I bought it from just over 6 months ago as they changed 3 of the 4 tyres when I bought it.
Just thought I'd ask first before making any judgement!
Cheers!
It did tramline a little but having had larger alloys on previous cars I'm used to this and put it down to having larger wheels....it seems I might have been a little naive with that. /facepalm
I've emailed the dealer and asked them what they propose as the one tyre with the uneven wear is nigh on bald on the edge now. Good job I spotted it when I did.
Worryingly that was a BMW dealer too...
I've emailed the dealer and asked them what they propose as the one tyre with the uneven wear is nigh on bald on the edge now. Good job I spotted it when I did.
Worryingly that was a BMW dealer too...
stoocake said:
Well spotted! Seems a pretty fundamental mistake to make for a tyre fitter.
The main dealer should of still checked the basic what tyre was where and condition, that is why you pay £80 plus an hour.I dont use the main dealer here I use a trusted Indy because I found out they were not actually carrying out all the work you pay for.
On an M3 the valve clearances are supposed to be checked/ shimmed. I found out from an insider they dont usually bother. I wont pay dealer prices for less work when the car is out of warranty.
If the car is in warranty I dont think you have much choice than to use them, if not for the stamp in the book.
Edited by nottyash on Thursday 20th September 16:46
Gra76 said:
So I went out to check the tyre sizes. It seems the offside front and rear tyres are both 225/40/18 and the nearside front and rear tyres are both 255/35/18....

Gra76 said:
Aren't the wider tyres supposed to go on the back rather than both on one side?
Yes, definitely.But, in answer to your original question, my previous set of run flats had very heavy wear on the shoulder, but a decent amount of tread across the majority of the middle, and needed replaced as a result.
Gassing Station | BMW General | Top of Page | What's New | My Stuff



