Bonnet Release
Discussion
I had the same problem, the knurled knob has a screw that fixes it to the shaft, I think its possible for it to get jammed on a ball bearing that locates the locked/unlocked position, you can loosen the screw and adjust it for tightness. I beleive you shouldn't leave it too loose as it can unlock due to vibration, but I've not experienced this.
I have to say i have had the same problem with mine and no amount of pulling /pushing/turning once my bonnet release knob had tightened would release it i just had to loosen the allen cap screw that had been fitted to replace the grub screw and all was fine again, nice smooth action, sorted.
Gassing Station | Cerbera | Top of Page | What's New | My Stuff




