E46 318i SE Problem
Discussion
A friend of mine has the following problem, he has had it to 2 garages with no luck . One has suggested a sticking valve?
Anyone have any idea's?
When the car is started from cold it runs awful,ie missing spluttering sometimes cuts out, lack of power,wont pull properly.
After 10-15 mins when the engine is warm the car runs ok.
(sometimes turning the engine off and restarting makes it better)
Anyone have any idea's?
When the car is started from cold it runs awful,ie missing spluttering sometimes cuts out, lack of power,wont pull properly.
After 10-15 mins when the engine is warm the car runs ok.
(sometimes turning the engine off and restarting makes it better)
Crankshaft or camshaft sensors can cause this sort of issue, as can a vacuum leak.
t all the time as the timing would be permanently off, it wouldn't run better once warmed up as the timing still wouldn't be correct.
Mustard said:
Jumped a tooth on the timing chain? .... Plastic tensioner is suspect on these (there is a modified version)
Worth checking
If it had jumped a tooth on the timing chain it would run like sWorth checking
t all the time as the timing would be permanently off, it wouldn't run better once warmed up as the timing still wouldn't be correct.4rephill said:
Crankshaft or camshaft sensors can cause this sort of issue, as can a vacuum leak.
t all the time as the timing would be permanently off, it wouldn't run better once warmed up as the timing still wouldn't be correct.
Agree with the vacuum leak, spray some brake cleaner, or wd40, or something else comustable around the inlet manifold rubber pipes etc, see if the engine revs change.Mustard said:
Jumped a tooth on the timing chain? .... Plastic tensioner is suspect on these (there is a modified version)
Worth checking
If it had jumped a tooth on the timing chain it would run like sWorth checking
t all the time as the timing would be permanently off, it wouldn't run better once warmed up as the timing still wouldn't be correct.B3ALP said:
Hi again
I have now drove this car and it is missing all the time (even when warm)
under 2 thousand revs above 2 thousand and it runs fine?
Cannot find any leaks but need to investigate more.
What about the air flow meter could this give these symptoms
If you suspect the Mass Air flow meter (MAF), disconnect it and see how the car runs (The engine should default to a basic setting that allows the car to run, albeit on a richer mixture setting)I have now drove this car and it is missing all the time (even when warm)
under 2 thousand revs above 2 thousand and it runs fine?
Cannot find any leaks but need to investigate more.
What about the air flow meter could this give these symptoms
If the car runs smoother then your MAF is faulty.
If the car still runs rough then it's not the MAF.
(If it runs smoother with the MAF disconnected, don't be tempted to just run it that way from now on though as that can cause other issues. Running temporarily with the MAF disconnected is ok but you do need the MAF working to use the car everyday).
It could also be a spark plug or failing coil issue.
It needs to go somewhere with the correct diagnostic kit I'm afraid, otherwise you'll be chasing your arse, and it could easily cost you a fortune trying this and that.
A diagnostics from my specialist is about £45, and worth every penny.
Try finding someone like this :
http://pwebdesign.brinkster.net/bmeuroservice/cont...
but in your area.
A diagnostics from my specialist is about £45, and worth every penny.
Try finding someone like this :
http://pwebdesign.brinkster.net/bmeuroservice/cont...
but in your area.
Gassing Station | BMW General | Top of Page | What's New | My Stuff



