Tag Carrera - broken crown
Discussion
Never worn the Tag for a while and found that the crown snapped off. Did some research and apparently this is a common failure 
Anyone know where can I send it off for repairs? How much would the repair normally cost? I am not a knowledgeable watch man but this watch was bought 5 years ago on a special occasion so I would really like to repair it.

Anyone know where can I send it off for repairs? How much would the repair normally cost? I am not a knowledgeable watch man but this watch was bought 5 years ago on a special occasion so I would really like to repair it.
NeMiSiS said:
Straight forward repair.
Replace stem.
Release old stem using release button and unscrew remainder of broken stem from the crown, screw new stem to the old crown using locktight then simply insert back into the keyless works.
Things I would do during this job, replace battery (if it is quartz) replace case rear seal, and replace both stem and crown 'O' rings.
20 minutes.
Wow sounds like something I can do myself too! Do you mind saying which is the release button? There's only 2 button which is used for the stopwatch function.Replace stem.
Release old stem using release button and unscrew remainder of broken stem from the crown, screw new stem to the old crown using locktight then simply insert back into the keyless works.
Things I would do during this job, replace battery (if it is quartz) replace case rear seal, and replace both stem and crown 'O' rings.
20 minutes.
Can you also recommend a place I can buy the replacement part from?
FYI the stem is sheared clean from the crown. Below is how my crown look like :

Thank you.
You'll struggle to get the broken stem out of the crown. Might be possible to dissolve the broken part, or get it drilled out. Personally, I'd just buy a replacement crown and stem. Cousins probably have the parts.
The release button for the stem is on the movement. You have to remove the caseback to get to it.
The release button for the stem is on the movement. You have to remove the caseback to get to it.
clockworks said:
You'll struggle to get the broken stem out of the crown. Might be possible to dissolve the broken part, or get it drilled out. Personally, I'd just buy a replacement crown and stem. Cousins probably have the parts.
The release button for the stem is on the movement. You have to remove the caseback to get to it.
Ah perhaps a little bit too involving for me. It's an expensive watch and I don't want to risk destroying it. I'll have to ask around watch shops to see if they can repair. There are some online shops which requires me to send them my watch but to be honest I am a little bit wary of that...The release button for the stem is on the movement. You have to remove the caseback to get to it.
If you (or they) can get the correct parts, I'm sure Timpsons could fit the new stem and crown for you - it's no more difficult than changing a battery. Just be sure to check whether the stem needs to pulled out to the winding, date change or time setting position before pressing the release button. Get it wrong, and the clutch/castle gear can drop out of position (dial off job to get it all back together). This can happen on some ETA movements - been there, done that!
clockworks said:
If you (or they) can get the correct parts, I'm sure Timpsons could fit the new stem and crown for you - it's no more difficult than changing a battery. Just be sure to check whether the stem needs to pulled out to the winding, date change or time setting position before pressing the release button. Get it wrong, and the clutch/castle gear can drop out of position (dial off job to get it all back together). This can happen on some ETA movements - been there, done that!
Thanks for all the advice 
Gassing Station | Watches | Top of Page | What's New | My Stuff


