Rolex service
Author
Discussion

Ding Dong

Original Poster:

514 posts

306 months

Thursday 6th December 2012
quotequote all
My Rolex Sub has suddenly started losing up to 20 mins and hour - works fine for a while if manually wound. I am guessing the auto winding movement is failing. My question is, do I really need to spend £400+ on a service or could it be something simpler?

Zingari

947 posts

204 months

Thursday 6th December 2012
quotequote all
Sounds like it may need some new parts. When you rotate the watch can you feel the gyro of the auto half-wheel moving to add power? You should be able to hear/feel it.

When you wind it does the winder feel 'gritty'/notchy rather than smooth wind? Does the rapid date change flick over positively and centre the day in the window? If not both these are a good indication it needs a service.

Try the Watch Doctor (not personally used them) but lots have and rate their service. Cheaper and quicker than Rolex. They may give an assessment of your problem over the phone and a likely cost.

Edited by Zingari on Thursday 6th December 12:54

Vvroom

1,170 posts

221 months

Thursday 6th December 2012
quotequote all
There will be plenty of recommendations posted shortly, I think.

I was trying on an AP in Rockerfellas in Manchester yesterday and I asked about a service for my Sub, in passing, and they quoted £200 + VAT and a 10 day turnaround.

I can't vouch for them but I thought this was good value for a Rolex trained technician.

Arun_D

2,340 posts

226 months

Thursday 6th December 2012
quotequote all
Zingari said:
Sounds like it may need some new parts. When you rotate the watch can you feel the gyro of the auto half-wheel moving to add power? You should be able to hear/feel it.
On a side note, my SubC is the only auto I own where I honestly can't feel or hear the presence of the rotor whatsoever, try as I might in deadly silent ambient surroundings. More silent than a quiet thing in a church mouse's house. I like to think it's not my hearing as I can hear the movement ticking away when it's up to my ear.

Edited by Arun_D on Thursday 6th December 13:12

clockworks

7,818 posts

176 months

Thursday 6th December 2012
quotequote all
Does it keep running for a few hours, losing 20 minutes each hour? Does it make any difference if the crown is screwed down, or left unscrewed in the winding position?
Watches will generally run a little fast, then stop, if they aren't wound. At low amplitude, a balance will "vibrate" faster, so the watch will gain.

Losing huge amounts of time sounds more like a loose cannon pinion, faulty motion work or setting lever problem. If the watch was dropped, it could be a balance problem.

Personally, I'd send it back to Rolex, and let them fix it and refurbish the case/bracelet at the same time - unless it's an older model, where a refurb will devalue the watch.

Miguel Alvarez

5,194 posts

201 months

Thursday 6th December 2012
quotequote all
Arun_D said:
Zingari said:
Sounds like it may need some new parts. When you rotate the watch can you feel the gyro of the auto half-wheel moving to add power? You should be able to hear/feel it.
On a side note, my SubC is the only auto I own where I honestly can't feel or hear the presence of the rotor whatsoever, try as I might in deadly silent ambient surroundings. More silent than a quiet thing in a church mouse's house. I like to think it's not my hearing as I can hear the movement ticking away when it's up to my ear.

Edited by Arun_D on Thursday 6th December 13:12
Same in the Exp 2 and my Sub. Can only hear the ticking.

Zingari

947 posts

204 months

Thursday 6th December 2012
quotequote all
Miguel Alvarez said:
Arun_D said:
Zingari said:
Sounds like it may need some new parts. When you rotate the watch can you feel the gyro of the auto half-wheel moving to add power? You should be able to hear/feel it.
On a side note, my SubC is the only auto I own where I honestly can't feel or hear the presence of the rotor whatsoever, try as I might in deadly silent ambient surroundings. More silent than a quiet thing in a church mouse's house. I like to think it's not my hearing as I can hear the movement ticking away when it's up to my ear.

Edited by Arun_D on Thursday 6th December 13:12
Same in the Exp 2 and my Sub. Can only hear the ticking.
Must be why I'm so good in bed and in demand with the ladies rofl

AndrewWF

280 posts

173 months

Thursday 6th December 2012
quotequote all
The watch may possibly need demagnetising, but quite possibly just needs a service.

clockworks

7,818 posts

176 months

Thursday 6th December 2012
quotequote all
A magnetised watch generally runs fast.

tickious

1,401 posts

205 months

Monday 10th December 2012
quotequote all
clockworks said:
Does it keep running for a few hours, losing 20 minutes each hour? Does it make any difference if the crown is screwed down, or left unscrewed in the winding position?
Watches will generally run a little fast, then stop, if they aren't wound. At low amplitude, a balance will "vibrate" faster, so the watch will gain.

Losing huge amounts of time sounds more like a loose cannon pinion, faulty motion work or setting lever problem. If the watch was dropped, it could be a balance problem.

Personally, I'd send it back to Rolex, and let them fix it and refurbish the case/bracelet at the same time - unless it's an older model, where a refurb will devalue the watch.
Here here, get it back to Rolex. They'll do a proper job. And no one else can really refurb the sports cases like Rolex. It probably doesn't even = £100 per year for it's up keep and I'm sure you spend more than that on you motor. Which isn't running 24/7. Also if you leave it too long it can cost more as parts start to wear.
Just about to send my dweller back for some TLC. Can't wait to have it back like new again.

ecain63

10,653 posts

206 months

Thursday 13th December 2012
quotequote all
We (http://www.jandrjewelleryrepairs.co.uk/) do Rolex servicing, by a fully certified Rolex watchmaker. PM me if you are interested.

DKL

4,996 posts

253 months

Friday 14th December 2012
quotequote all
Send it to Duncan.
www.genesiswatchmaking.co.uk
it won't cost you £400 and it will come back looking and working like new.

tickious

1,401 posts

205 months

Saturday 15th December 2012
quotequote all
I still say for sports models, it's best sending back to Rolex. Movements are doable, but I don't think anyone can refurbish their cases like them.

ricola

490 posts

308 months

Sunday 16th December 2012
quotequote all
Watch doctors did a better job on my bracelet/case than Rolex did the previous few services, damn site faster and cheaper too!

tickious said:
I still say for sports models, it's best sending back to Rolex. Movements are doable, but I don't think anyone can refurbish their cases like them.

tickious

1,401 posts

205 months

Monday 17th December 2012
quotequote all
ricola said:
Watch doctors did a better job on my bracelet/case than Rolex did the previous few services, damn site faster and cheaper too!

tickious said:
I still say for sports models, it's best sending back to Rolex. Movements are doable, but I don't think anyone can refurbish their cases like them.
Is yours a sports model? And are you sure it went back to Rolex? If you took it to a shop it might have been done in house.

ricola

490 posts

308 months

Friday 21st December 2012
quotequote all
It's a bi-metal submariner, definitely went back to Rolex several times(via Ernest Jones), have the paperwork..

tickious

1,401 posts

205 months

Friday 21st December 2012
quotequote all
ricola said:
It's a bi-metal submariner, definitely went back to Rolex several times(via Ernest Jones), have the paperwork..

Nice. And no offence, it's just my opinion, but I think you're best sending it direct, as a lot of jewellers will put a 30% plus mark up on the Rolex price just for posting it.

David911RSR

1,446 posts

241 months

Friday 21st December 2012
quotequote all
DKL said:
Send it to Duncan.
www.genesiswatchmaking.co.uk
it won't cost you £400 and it will come back looking and working like new.
+ 1 and I believe he is now a Rolex certified service centre

dace

202 posts

241 months

Friday 21st December 2012
quotequote all
Just noticed he does not do Seadweller's???!

raptor600

1,356 posts

177 months

Friday 21st December 2012
quotequote all
DKL said:
Send it to Duncan.
www.genesiswatchmaking.co.uk
it won't cost you £400 and it will come back looking and working like new.
...it costs £430. Seems an awful lot to me - surely it is the same or cheaper sending it back to Rolex?