CADCAM drawing Griffith dashboard?

[infinity]

As i am currently doing a full respray, retrim and some mechanical upgrades to a (LHD)Griff 500 i would like to make a new dash as well. I have an early 500 but bought all the meters for the newer type (with the alu bezels). Since they are bigger and the later Griffs have a slightly different lay-out i have to let somebody cut the aluminum for me. (The car is LHD, otherwise i could just re-veneer a secondhand RHD.....) I don't think it matters if i have the CADCAM for a RHD because we will just reverse it and "use" the backside.

Any further recommendations are welcome!

[TVRinBFG]

You have the dials for a '96 onwards car? But an early dash? TVR MADS do lhd veneer dash and heater panel for the later cars at £200 plus VAT.

[V8 GRF]

I have a CAD drawing. The dial location might be wrong but I assume the outline will be OK.

PM me with your email if you'd like it.

[infinity]

Just mailed you David!! Thnx in advance.

[infinity]

TVRinBFG said:

You have the dials for a '96 onwards car? But an early dash? TVR MADS do lhd veneer dash and heater panel for the later cars at £200 plus VAT.

Yes James, but how do i get the right "holes" at the right places? I think i first need a new "base" to start with.

[TVRinBFG]

Dave - you to88er! There goes my steak supper!
Dries - the holes are where they should be for a '96 onwards lhd Griffith.