standard induction pipework/afm elbow

[BountyHunter]

hi guys,

does anyone have any idea where I can get a set of standard induction pipework and afm elbow for a 450 ? (same as the 400 afaik) or has anyone fitted the smoothbore and has a standard set they can sell

[pwd95]

Might do this upgrade to mine in the next month or so. You got one yet?

[Mr Supercharged]

I must have some in my garage. Although it will have been shortened. If it's any good PM me. Cheers.

[estutjaweh]

I've got them both lying in the garage. Top hose is in perfect nic' - the metal ribs are showing through the plastic (outside) on the bottom one in places. It's still airtight as far as I remember. Postage could be a bit much though. Where abouts in South wales are you?

[K4TRV]

Having a very early ('93) Chim 400, I replaced the inlet & elbow over three years ago, for smoothbore.

The old inlet on the outside looked "fine", but inside the liner was letting go and blocking/restricting the flow.

I can't understand why you would want someone else's used pipework, as it has a tendancy to do what mine did, but not look outwardly any different from new???

The ACT Kit is very good, a bit mn-power need to get it to fit through the bulkhead at the side of the Radiator.

I think, IMVHO, it's a no-brainer to go smooth bore - yours must be 13/14 years old, at least??

HTHs

Trev

[BountyHunter]

K4TRV said:

I can't understand why you would want someone else's used pipework, as it has a tendancy to do what mine did, but not look outwardly any different from new???

I think, IMVHO, it's a no-brainer to go smooth bore - yours must be 13/14 years old, at least??

hi trev,

there is a method to my madness

[K4TRV]

BountyHunter said:

hi trev,

there is a method to my madness