What colour to hide a bad shape
Discussion
a single seater track car of mine has undergone some fairly serious bodywork surgery to enclose a new engine package. The net result of this is some fairly 'challenging' lines at the rear.
it is going in for paint next week and i am still undecided on what colour scheme would best hide what can only be described as a hunchback.
her 'good side'

the not so good side

over to you guys
it is going in for paint next week and i am still undecided on what colour scheme would best hide what can only be described as a hunchback.
her 'good side'

the not so good side

over to you guys
wombat172a said:
Is "try again" not an option then?
i'm afraid not, the shape is defined by the 'hard points' of the mechanical package, there is only a few mill clearance at the critical places to try and minimise the shape.i really just need to cover it up as well as i can, i was thinking the colour of tarmac, essentially, a dark grey, almost like the titanium grey i had on a previous car of mine (alfa GTV)
Do it two colours. Black and silver - use the black underneath and draw the line of the black up at the back and then a dark silver on top. A strong colour line will hide the ugly rear end - especially if you red stripe it between the two. That wy the eye follows the colours, not the shape.
GroundEffect said:
Why do you need to cover it up at all?
there's quite a lot going on in there (now all the boost pipes and heat management gubbins are in there, space is even tighter)
it's a bit of a spagetti mess in there through necessity and needs covering over.
I knew the transverse layout was a mistake, lol. but the learning experience it has afforded me in rebuilding it has been unique, i have gained so much experience doing it that the end result is in many ways, immaterial...
Greg_D said:
there's quite a lot going on in there (now all the boost pipes and heat management gubbins are in there, space is even tighter)

it's a bit of a spagetti mess in there through necessity and needs covering over.
I knew the transverse layout was a mistake, lol. but the learning experience it has afforded me in rebuilding it has been unique, i have gained so much experience doing it that the end result is in many ways, immaterial...
I agree with GroundEffect here - even though it is transverse I don't think it's bad-looking. Also, surely leaving it exposed for the time being will help with the heat-management issues.
it's a bit of a spagetti mess in there through necessity and needs covering over.
I knew the transverse layout was a mistake, lol. but the learning experience it has afforded me in rebuilding it has been unique, i have gained so much experience doing it that the end result is in many ways, immaterial...
I reckon you leave it exposed, '70s F1-style, until you scrape together the funds to make a proper glassfibre cowl for it, possibly with an airbox. In the meantime, it looks fine with nothing on it.
Gassing Station | General Gassing | Top of Page | What's New | My Stuff








