Running in a new diesel car.
Running in a new diesel car.
Author
Discussion

busta

Original Poster:

4,504 posts

264 months

Thursday 11th April 2013
quotequote all
It's quite common for people to talk about new diesel engines taking a while to loosen up and reach their peak economy; Often figures of 5 or 10 thousand miles are quoted.

I can't think of any other modern products that require a similar breaking in period. Is it true? If so, why do people accept it as normal for a modern mass produced car?

S0 What

3,358 posts

203 months

Thursday 11th April 2013
quotequote all
Cos engines have allways taken time to loosen up ?
I suppose the main issue is that who would buy a "new" car with 10,000 miles on the engine and no way of knowing how it was put on it, then again manufacturers could allways run every engine up for 10K and pay the fuel ect and then not pass the HUGE costs on the customer.
Naaaaaaaaa

Edited by S0 What on Thursday 11th April 23:38

busta

Original Poster:

4,504 posts

264 months

Thursday 11th April 2013
quotequote all
Do they? I've never heard the same said of a modern petrol.

fangio

989 posts

265 months

Friday 12th April 2013
quotequote all
Just drive it!

When I was a lorry driver, one of the older 'senior' drivers always got the new wagons and hammered them from day one. They were always the best pullers in the fleet, and the fastest!

Edited by fangio on Saturday 13th April 18:53

beanbag

7,346 posts

272 months

Friday 12th April 2013
quotequote all
Just keep it below 2000rpm more or less for the first 600-700 miles or 1000km.

It doesn't affect economy. It just allows the engine to run in properly.

TheTurbonator

2,792 posts

182 months

Friday 12th April 2013
quotequote all
The manufacturers usually recommend, that you only have to go easy on the engine for the first 1000 miles but that you shouldn't expect to get full HP or economy figures, until about 10,000 miles, which is when the engine has become fully run-in and is at it's most efficient.

Off topic a little but my Granddad, who is an old RAF engineer, used to always tell me, that an engine is always running at it's best, just before it breaks.

Fastdruid

9,413 posts

183 months

Friday 12th April 2013
quotequote all
Drive it like you stole it.

Mollycoddling a new engine prevents the rings from bedding in properly and it'll never make the best power or not burn oil (apart from in the case of a Diesel the oil it's meant to burn!)

Plus it's a modern Diesel so it'll be f**ked in <100k so who cares. wink

Skodaku

1,805 posts

250 months

Friday 12th April 2013
quotequote all
TheTurbonator said:
The manufacturers usually recommend, that you only have to go easy on the engine for the first 1000 miles but that you shouldn't expect to get full HP or economy figures, until about 10,000 miles, which is when the engine has become fully run-in and is at it's most efficient.

Off topic a little but my Granddad, who is an old RAF engineer, used to always tell me, that an engine is always running at it's best, just before it breaks.
Have had a very similar quote from my F I L who was a Flight Engineer on Halifaxes and Lancasters. Mind you, he is one of the least mechanically-minded guys I've ever met but still wnt on to gain a PhD in Chemical Engineering post-war. He is still, however, a b****y wizz at analysis.

Mr2Mike

20,143 posts

286 months

Friday 12th April 2013
quotequote all
busta said:
Do they? I've never heard the same said of a modern petrol.
All internal combustion engines will loosen up as they get run in, it's just blatantly obvious confused

busta

Original Poster:

4,504 posts

264 months

Saturday 13th April 2013
quotequote all
So its perfectly normal and acceptable that your 50mpg, 150hp car will actually be a 45mpg, 140hp car for the first year of ownership?

davepoth

29,395 posts

230 months

Saturday 13th April 2013
quotequote all
busta said:
So its perfectly normal and acceptable that your 50mpg, 150hp car will actually be a 45mpg, 140hp car for the first year of ownership?
Yup. No matter how good the machining, it's never quite perfect. That adds a bit of friction A few thousand miles of extremely gentle rubbing with oil lubrication gets everything mating together smoothly.

wemorgan

3,583 posts

209 months

Saturday 13th April 2013
quotequote all
1000 miles should be enough to run in an engine for good economy. The official fuel economy test are done on cars with this mileage.

My new diesel car achieved the combined mpg on the 2nd tank of fuel.

On running in the handbook is quite clear. Drive below max throttle and revs, but use all the remaining rev range.

Edited by wemorgan on Saturday 13th April 07:14

covmutley

3,385 posts

221 months

Saturday 13th April 2013
quotequote all
My old Honda civic improved noticeably after 15000 miles

Superhoop

4,919 posts

224 months

Saturday 13th April 2013
quotequote all
wemorgan said:
1000 miles should be enough to run in an engine for good economy. The official fuel economy test are done on cars with this mileage.
No they're not.

The VCA said:
The cars tested have to be run-in and must have been driven for at least 1,800 miles (3,000 kilometres) before testing.

MajorProblem

4,700 posts

195 months

Saturday 13th April 2013
quotequote all
Drive normally, don't labour the engine.

5k rpm in the right gear will be easier on the engine than 2k rpm in the wrong gear.

Bezza1969

777 posts

179 months

Saturday 13th April 2013
quotequote all
Fastdruid said:
Drive it like you stole it.

Mollycoddling a new engine prevents the rings from bedding in properly and it'll never make the best power or not burn oil (apart from in the case of a Diesel the oil it's meant to burn!)

Plus it's a modern Diesel so it'll be f**ked in <100k so who cares. wink
..oh thats charming, I'll just make a note never to buy a used car from you!!

IMO it makes sense to treat an engine with some sympathy when its new. Dont molly coddle it, but personally I would red line it for 1000 miles. I always understood engines like VAG diesels dont actually perform their best until about 30,000 miles. Hence I would always buy used!!!

Dunclane

1,465 posts

200 months

Saturday 13th April 2013
quotequote all
I always take it easy on the engine, brakes and suspension for the first 750-1000 miles. My Octavia VRS has just started to loosen up and feel quick at 35k.

Fastdruid

9,413 posts

183 months

Saturday 13th April 2013
quotequote all
Bezza1969 said:
Fastdruid said:
Drive it like you stole it.

Mollycoddling a new engine prevents the rings from bedding in properly and it'll never make the best power or not burn oil (apart from in the case of a Diesel the oil it's meant to burn!)

Plus it's a modern Diesel so it'll be f**ked in <100k so who cares. wink
..oh thats charming, I'll just make a note never to buy a used car from you!!
You're safe, I wouldn't be buying one new, it's a diesel, who cares.



beanbag

7,346 posts

272 months

Saturday 13th April 2013
quotequote all
swerni said:
Why would you want to do 5k rpm in a diesel?
That would be revving the crap out of my engine!! 4.5k is the limit on my BMW 2 litre diesel.

And to note, you will [b]not[/not] stress a diesel at 2k rpm! If you are stressing it, you're in the wrong gear.

MajorProblem

4,700 posts

195 months

Saturday 13th April 2013
quotequote all
beanbag said:
swerni said:
Why would you want to do 5k rpm in a diesel?
That would be revving the crap out of my engine!! 4.5k is the limit on my BMW 2 litre diesel.

And to note, you will [b]not[/not] stress a diesel at 2k rpm! If you are stressing it, you're in the wrong gear.
Like I said, in the wrong gear.