Would an MOT tester or a service technician inspect bearings
Discussion
We had a company vehicle in the garage on Wednesday this week for an MOT and scheduled service, as part of this they suggested that the front and rear brakes needed changing, which we agreed to as we usually get a sensible discount.
No other advisory notices were issued, on collecting it the van was driven 5 miles and parked overnight. The next morning when collected it had developed a strange grinding noise from the steering, which was diagnosed as a front wheel bearing.
So two decent sized bills in three days, the second bill being something that my (admittedly limited) knowledge of vehicle servicing would have been spotted by not one but supposedly two thorough checks.
No other advisory notices were issued, on collecting it the van was driven 5 miles and parked overnight. The next morning when collected it had developed a strange grinding noise from the steering, which was diagnosed as a front wheel bearing.
So two decent sized bills in three days, the second bill being something that my (admittedly limited) knowledge of vehicle servicing would have been spotted by not one but supposedly two thorough checks.
chrisw666 said:
We had a company vehicle in the garage on Wednesday this week for an MOT and scheduled service, as part of this they suggested that the front and rear brakes needed changing, which we agreed to as we usually get a sensible discount.
Just pads, or discs as well? Disc hard to get off resulting in a few bashes with a big hammer, putting strain on the bearing which fails after next use. Or excess release fluid used at hub which washed some grease from the bearing.
JM said:
chrisw666 said:
We had a company vehicle in the garage on Wednesday this week for an MOT and scheduled service, as part of this they suggested that the front and rear brakes needed changing, which we agreed to as we usually get a sensible discount.
Just pads, or discs as well? Disc hard to get off resulting in a few bashes with a big hammer, putting strain on the bearing which fails after next use. Or excess release fluid used at hub which washed some grease from the bearing.
Gassing Station | General Gassing | Top of Page | What's New | My Stuff


