essex V6 inlet manifold gasket position

[chris52]

Hi a bit stuck as there apears to be two ways to fit the inlet gasket. The waterways are different on either side some have large holes some pin holes etc. I have pictured the two possibilites if anyone could tel me which is correct that would be a massive help

POSITION 1


POSITION 2


Many thanks
Chris

[pridaux]

The second picture I think from memory give Adrian a call and he will confirm I am sure
Andrew

[Slow M]

Does the underside of the intake manifold not offer any hints?

Best,
B.

[chris52]

All sorted it was number 1
If you look at the cork in the centre, one is curved one is straight to match the block.
Cheers for the help
Chris

[bluezeeland]

make sure to apply some blue silicon to the 'creases' at the fore and aft, thats were oil will leak....

also apply some coppaslip to the water-channels !

[chris52]

I did apply the silicone but not the coppaslip will it make much difference?
Chris

[bluezeeland]

just a precaution, a little smear will tighten better