Cam Belt Failure - Seasonal?
Discussion
I can't think of the last time I actually saw a failed timing belt as a result of the belt itself letting go.
Most of the ones I've seen involve disintegrated pulleys, seized tensioners/water pumps or a failed accessory drive belt flailing around and ripping the timing belt in the process.
Most of the ones I've seen involve disintegrated pulleys, seized tensioners/water pumps or a failed accessory drive belt flailing around and ripping the timing belt in the process.
legless said:
I can't think of the last time I actually saw a failed timing belt as a result of the belt itself letting go.
Most of the ones I've seen involve disintegrated pulleys, seized tensioners/water pumps or a failed accessory drive belt flailing around and ripping the timing belt in the process.
A little reminder for you:Most of the ones I've seen involve disintegrated pulleys, seized tensioners/water pumps or a failed accessory drive belt flailing around and ripping the timing belt in the process.

ismellburning said:
Evoluzione said:
Pardon my ignorance, what exactly are we looking at here?ismellburning said:
Pardon my ignorance, what exactly are we looking at here?
Those are the valves that let fuel/air charge in, and burnt exhaust gases out of the cylinder. They should all be dead straight and in one piece. In this case, the cam belt has snapped, so the cams have stopped rotating and some of the valves have been left extended whilst the pistons continue to go up and down. Most modern engines have an "interferance" design, which means that if the valves are down then the piston will hit them before it reaches top dead centre and starts to go down again. This is A Bad Thing. As well as the valve damage, the tops of the pistons and the valve seats (the guides that the valves slide in inside the top of the engine) are probably damaged too. It's likely that this engine is only good for scrap. Get your cambelts done on time folks!(alternatively, get a car with a camchain)
(alternatively to the alternative, get an RX7 or an RX8. No cams = no problems, right?)
cptsideways said:
mat777 said:
For a cambelt to just snap by itself (assuming its not defective), youll have to be running it for long after its due milage/age to be services
You've not owned an Alfa have you 
BrewsterBear said:
ismellburning said:
Are you kidding? It's a broken belt, many bent valves and one valve which has broken and rattled around inside the cylinder, but the looks of it. This is what happens when a cambelt breaks on an interference engine.
Gassing Station | General Gassing | Top of Page | What's New | My Stuff



