Can you ask the council to remove a speed bump?
Can you ask the council to remove a speed bump?
Author
Discussion

kiethton

Original Poster:

14,669 posts

211 months

Thursday 25th April 2013
quotequote all
Well I've collected the new car yesterday and on driving back to my house have found that I can't get to my house, without scraping the underside frown (large brick riased humps on either end of the road that my road leads from).

Is there any way that I can request the council to remove the humps? - well just the one would be ok!

Although the new car is lowered the offending hump is high, my dad's standard Jag S type scraped as did my previous 335i.

Gratuitous car picture:



TameRacingDriver

20,662 posts

303 months

Thursday 25th April 2013
quotequote all
Of course you can ask. I bet you already know the answer. One reason why i would never bother with a lowered car tbh (among others).

PaulMoor

3,209 posts

194 months

Thursday 25th April 2013
quotequote all
If it is unreasonably high, yes they will lower it. There was one near me that was reduced in hight because it was far to high.

Don't expect them to see the speed bump as being the problem when your car is lowerd though.

Edited by PaulMoor on Thursday 25th April 10:29

mad4amanda

2,410 posts

195 months

Thursday 25th April 2013
quotequote all
How high is it if it is over 100mm it is not correct spec and should be removed .

kambites

71,721 posts

252 months

Thursday 25th April 2013
quotequote all
As above, if a standard Civic is grounding on it it's too high and I suspect they will lower it (rather than risk being sued for damage). If your car has been lowered to below about 100mm you probably have no chance.

kiethton

Original Poster:

14,669 posts

211 months

Thursday 25th April 2013
quotequote all
The car is on lowered springs front and coilovers rear, but the exhaust B pipe hangs lower (it's this which catches).

This is the table in question (if streetview works):

http://maps.google.co.uk/maps?hl=en&q=maps+bro...

You will notice that it's sunk slightly on the left, going up the hill. I turn left onto Keswick Road from there.

anonymous-user

85 months

Thursday 25th April 2013
quotequote all
The speed table at the junction with Keswick Rd doesn't look particularly sunken, it looks like it follows the natural (quite steep) profile of the road. I'll add a disclaimer that Google street view images aren't the best for estimating dimensions, but it looks pretty acceptable to me.


kambites

71,721 posts

252 months

Thursday 25th April 2013
quotequote all
kiethton said:
The car is on lowered springs front and coilovers rear, but the exhaust B pipe hangs lower (it's this which catches).
How low is the lowest point?

If it's below about 10cm, the council will just (reasonably enough really) tell you go and fix your car.

kiethton

Original Poster:

14,669 posts

211 months

Thursday 25th April 2013
quotequote all
kambites said:
kiethton said:
The car is on lowered springs front and coilovers rear, but the exhaust B pipe hangs lower (it's this which catches).
How low is the lowest point?

If it's below about 10cm, the council will just (reasonably enough really) tell you go and fix your car.
I'll need to check later as I'm currently at work and only collected the car last night. It wouldn't surprise me if it's around 10cm as it catches on almost all humps, I have to drive with one wheel on the humps that you are meant to straddle as it grounds there also.

Mr2Mike

20,143 posts

286 months

Thursday 25th April 2013
quotequote all
kiethton said:
The car is on lowered springs front and coilovers rear, but the exhaust B pipe hangs lower (it's this which catches).
That's because the B pipe is a stupid design on the EP3 which hangs down unnecessarily low. I have the original exhaust and suspension and mine scrapes the B pipe going in and out of my driveway.

kambites

71,721 posts

252 months

Thursday 25th April 2013
quotequote all
kiethton said:
I'll need to check later as I'm currently at work and only collected the car last night. It wouldn't surprise me if it's around 10cm as it catches on almost all humps, I have to drive with one wheel on the humps that you are meant to straddle as it grounds there also.
Time to fit some more sensible suspension then, I feel. smile

Sam1990

398 posts

198 months

Thursday 25th April 2013
quotequote all
There is very little you can do if the hump conforms to road laws and your car is modified. I face your same problem with 2 speedhumps on the way to work. I have noticed the lack of CCTV in the area and often questioned whether or not I should borrow a pneumatic drill to solve the problem. The council actually removed all of the speeedhumps in the area apart from this one stretch of road.

My solution to the problem is to bike to work until they continue with the removal of the speedhumps. Although I would love nothing more than to assist in this removal process with said pneumatic drill!