Mod wise amp kit
Mod wise amp kit
Author
Discussion

rbryant

Original Poster:

318 posts

270 months

Thursday 30th September 2004
quotequote all
Hi guys, I have bought a mod wise aerial amplifier to boost the generally crap radio signal. Fitting basically consists of threading a rather fat wire from boot to radio, so I am wondering:

1) can I get it through the centre console

2) does it have to go through the sill as per this link
www.pistonheads.com/gassing/topic.asp?h=0&f=8&t=51585 (thanks MOD500 but it sounds a bit tricky)

3) any other wiring tips and hints

4) do I need a special tool to get the Pioneer radio cassette unit out?

Thanks

Ribol

11,993 posts

287 months

Thursday 30th September 2004
quotequote all
I would run it down the nearside above floor level. You can come out on the n/side by the head unit, down to the floor, under the floor mat. Keep going towards the boot until you get to the bottom seat belt mounting by the sill where you can cheat if you do not want to unbolt anything. Then you get into the void where the door locking solenoids are and over the arch where there is a hole big enough to get an arm through (although you cannot reach it). You are in the boot.

Pioneer original stereo requires two flat keys one for each side, you can get away with two flat bits of metal if pushed.

Good luck,

Ivan

rbryant

Original Poster:

318 posts

270 months

Thursday 30th September 2004
quotequote all
Thanks Ivan, sounds not too bad. Great pic of your car by the way.

Richard

Jem

548 posts

269 months

Friday 1st October 2004
quotequote all
ooh,

do keep us updated on the reception performance...

J

rbryant

Original Poster:

318 posts

270 months

Sunday 12th December 2004
quotequote all
Works great. Basically its so unobtrusive you forget all about it, but no longer does Radio 4 come and go on my drive to work.