Rover 416 misfire
Author
Discussion

Beelzebowler

Original Poster:

2 posts

163 months

Tuesday 30th April 2013
quotequote all
Morning! My old '98 416 has recently developed an alarming habit of drinking the cooling fluids, overheating and misfiring on startup. I've changed the inlet manifold gasket a few days ago and changed the oil, which was black as a coal mine at midnight, no Bailey's in there at all. There doesn't seem to be any coolant under the car, or oil in the coolant. Three days on though, the misfire is still there, and the coolant seems to be disappearing still. I'm monitoring the coolant as it could merely be air escaping at this point. I was just wondering if anyone might have any pointers as to what might be causing the misfire? It's only for about 10 seconds and it runs sweet as a nut afterwards. Help?

McWigglebum4th

32,414 posts

235 months

Tuesday 30th April 2013
quotequote all
A K-series?

First thing i would do is a new rotor arm, distrubutor cap, plugs and leads.

The rest of the posts will tell you the head gasket is gone and you should scrap it

Si.P

44 posts

269 months

Tuesday 30th April 2013
quotequote all
As far as I know the 1.6 is a Honda engine so not a k series. Have you changed the plugs? Might be worth a go

MysteryLemon

4,968 posts

222 months

Tuesday 30th April 2013
quotequote all
Disappearing coolant could well be that thought. Mayo in the oil isn't the only sign.

Are you getting white smoke from the exhaust? If you haven't got any leaks then you could well be burning that coolant via a broken head gasket.

Rickyy

6,618 posts

250 months

Tuesday 30th April 2013
quotequote all
Does it have individual coil packs? If so check these. If not, check the HT leads or even pull the plugs out and check the condition.

s3fella

10,524 posts

218 months

Tuesday 30th April 2013
quotequote all
Worth trying leads, but often first symptom of that is unwillingness to actually start. It will be a k series on a 98.

rosscobmw

350 posts

189 months

Tuesday 30th April 2013
quotequote all
My omega just got these symptoms recently. Missfire on startup, using water, missfire under full throttle. Its my headgasket, and I'm going to assume thats exactly what your problem is unfortunately

Beelzebowler

Original Poster:

2 posts

163 months

Tuesday 30th April 2013
quotequote all
It is indeed a K-series. Changed the plugs, the leads I changed about a year ago when I bought the car. Haven't changed them again yet. It's covered just over 100k miles, so I know with absolute certainty the head gasket has been done at some point. I'll try the rotor/cap/leads, see if that fixes it. No white smoke more than normal, certainly not enough to indicate HGF. The blowers blow nice n warm too, so I'm not overly concerned about HGF.

Nigel Worc's

8,121 posts

219 months

Tuesday 30th April 2013
quotequote all
I was one of the unfortunate souls to have a K series once, although mine was the 1.8.

Coolant loss (on one occasion) was down to the inlet manifold, and a missfire on one occasion was down to a degrading plug cap, you seem to have already changed those, and it was very obvious to the naked eye once you removed the coilpack/plugpack assembly.

I'm unsure of your 1.6 is the same setup as the 1.8, as I only owned one, and am firmly in the "scrap it camp" as a result.

Good luck chap, fooking heaps of ste they are.