How much brake binding is normal?
How much brake binding is normal?
Author
Discussion

Howard-

Original Poster:

4,964 posts

233 months

Tuesday 30th April 2013
quotequote all
Since I changed my front pads to proper OEM ones to eliminate the rattling from the cheap Pagid ones, I've noticed one of the wheels is binding slightly.

The wheel barely gets any warmer than the opposite one - perhaps a fraction. I only noticed it because the car seems to just about "stop itself" as you're crawling along and the car is stopping - I'm talking about speeds so slow that it's a lot slower than even walking pace, if that makes sense. There's a tiny jolt as the car comes to a final stop. Most people probably wouldn't notice.

But I'm anal. Should I have the lot apart again and make doubly sure everything's clean and operating freely?

It was fine with the old pads and they weren't that worn. The piston went back in nice and easily (so easily that I did it by hand) so I'm loathe to believe the caliper is sticking. But it probably is, knowing my luck.

The wheel can be turned no problem by hand but there is a small amount of resistance.

Blue Oval84

5,399 posts

192 months

Tuesday 30th April 2013
quotequote all
Howard- said:
Since I changed my front pads to proper OEM ones to eliminate the rattling from the cheap Pagid ones, I've noticed one of the wheels is binding slightly.
Sorry I can't help much with the actual question, but "cheap pagid ones"?

Aren't they OEM suppliers to Aston Martin? They're certainly the most expensive pads and discs that I can buy from ECP for my Mondeo. I found that when I fitted Pagid to the rear and replaced the knackered old ones the rattling from my car stopped...

If it's sticking at all I'd think the caliper may need some attention though?