Need threaded bolt 300x10mm for winding bearing in...

[VinceFox]

I have to wind a bearing in to a swingarm on a project bike. It can't be impact driven. I need to find a bolt or SOMETHING that's threaded and a good 30cm long, but small enough to pass through the hole in the centre of a socket.

Any ideas what i can source one from?

[McWigglebum4th]

Its called stud bar

[dudleybloke]

buy a length of allthread, most diy places stock it.

[VinceFox]

With some trepidation, i just googled that and yes, it is what i was after. Cheers!


On an unrelated note i may now be in a civil partnership.

[tubbystu]

A piece of threaded bar (aka studding) ?

[Oldandslow]

Yep, sounds like you need M10 threaded bar a couple of M10 nuts and some washers.

[VinceFox]

Spot on, thanks cheps. B&q do it?

[MajorProblem]

B and Q might do it but it will be cheap st and probably snap and take your eye out.

Look for a local fasteners shop like Bapps industrial.

[VinceFox]

"Bapps"

[SV8Predator]

VinceFox said:

"Bapps"

[VinceFox]

SV8Predator said:

VinceFox said:

"Bapps"

I'm hungry now.