Check Mate plate
Discussion
Would this be big enough to make sill plates for the early cars ?
following by abortive attempt to buy a near full sheet and "share it out" I did later go back and persuade the guy to cut me an undamaged piece from virtually the middle, enough for just a pair.
If anyone wants to persue it PM me for details. They also had a sheet of slightly heavier gauge.
following by abortive attempt to buy a near full sheet and "share it out" I did later go back and persuade the guy to cut me an undamaged piece from virtually the middle, enough for just a pair.
If anyone wants to persue it PM me for details. They also had a sheet of slightly heavier gauge.
great spot Philpot
Unfortunately even for the S1 Vixen, with shorter doors you need 800x120mm per side these are all too small. Shame
A quick google pulls up about 4 companies still listing the sheet as stocked. are these the ones you checked? or are these just "ghost" products?
Also, didn't Steve Reid allude to having some available at one time?
I will be needing some at some point, so if its available I'd love to know
Unfortunately even for the S1 Vixen, with shorter doors you need 800x120mm per side these are all too small. Shame
A quick google pulls up about 4 companies still listing the sheet as stocked. are these the ones you checked? or are these just "ghost" products?
Also, didn't Steve Reid allude to having some available at one time?
I will be needing some at some point, so if its available I'd love to know
Edited by Astacus on Sunday 12th May 18:01
Gassing Station | TVR Classics | Top of Page | What's New | My Stuff