urgent! where is the inertia switch

[ger man]

Hi all!

After body off restauration and almost complete rebuilt i have´t any power
on my fuel pump cable.and the ! ((exclamation mark?!?)) on my warning light
symbol panel is luminating.
i think it is the inertia switch. but where is he and how is he lookin.
the fuses are ok. maybe another fault is the fuel pump relay?
i hope you can send me some help to germany.
thanks dennis

[GasMunkey]

If its any thing like the Chims it just above the glove box

[GJR]

Hi Dennis, As GasMunkey says it should be behind the glove box. Open the clove box, if you reach inside and to the top you should be able to feel a button. According to the manual the button should be raise if the inertia cut-off has been activated. Relay is also another common possibility but I've never observed the ! lamp due to a failed relay?!

[V8Bart]

It is indeed accessible through the glove box, open it, force it as wide as it will go, reach in through the gap and there is a flat rubber top the does not feel like a switch.
press the top, light click and your cooking.

[Hedgehopper]

Press the rubber button.............

[rigga]

Was under the impression the mil lamp wasn't connected on the tvr application and needs to be enabled first when mapped by M Adams?

[ger man]

Thanks all!
The inertia switch wasn´t the fault.
The "!" Symbol is a warning light for less Breakfluid.
Now the the pump is running and the engine turning.
but sadly the griff is not waking up.
Tomorrow i will check the sparks firing.
once again;sorry for my english