Removing T350 seats.

[thatsprettyshady]

How is this done? I've gone underneath the car and there are a few bolts they just seem to spin when I use a socket on them, are there any bolts that need to be undone from within the car? I'm a little lost...

[Whitenoise1]

If its the same as the Tamora and it must be. There are 4 bolts on the bottom, these are the ones that are lower than the others because of the little extension bits on the chassis. You just then need to undo the seat belt mounting on the side of the seat to remove the seat from the car.

Hope this helps.

Andy

[RFC1]

4 nuts/bolts under the car to undo, but you need to stick a socket on the bolt heads on seat runners to stop them turning. put seat fully forward to do the rear ones ,then slide seat fully back for the fronts.

HTH Sandy

[thatsprettyshady]

Thanks, ill have a crack at it tomorrow

[natben]

If you can't get a socket on the bolts jammy a screwdriver down the side to stop the heads turning.
Replace them with hex headed bolts next time as an Alan key is easier to get in below the seats.