Discussion
The tank on the nearside is the swirl pot and has the cap without the spring loaded centre seal. This tank should be filled to the brim either hot or cold.
The tank on the offside is the expansion tank and has the cap with the spring centre. When cold this tank should be less than one third full. Some find almost empty when cold works for them.
Steve
The tank on the offside is the expansion tank and has the cap with the spring centre. When cold this tank should be less than one third full. Some find almost empty when cold works for them.
Steve
Steve_D said:
The tank on the nearside is the swirl pot and has the cap without the spring loaded centre seal. This tank should be filled to the brim either hot or cold.
Steve
Hmmm... each time I top this up, as suggested - I find the level back down below the engine inlet tube after any drive...Steve
Is that normal? No leaks I can find...
As I think Steve is saying. The nearside pot should always be full whether engine is hot or cold. The expansion tank is on drivers side (of std car anyway). In my case filling this results in its contents being blown out of the system leaving about 5mm in the bottom when cold. I have left it like this for 3 years now with no further losses. Some air is obviously required to absorb the expansion of the coolant which is incompressible.
Steve_D said:
As I said my car seems happy with about one third full. I also said others experience less. GTRMikie has said in the past that his is empty when cold.
Steve
As long as there is some coolant in the expansion tank when the engine is hot, there is nothing to worry about! I have one of the early plastic expansion tanks, so it is easy to visually check the level when the engine is hot.Steve
Gassing Station | Ultima | Top of Page | What's New | My Stuff


