TRACKING

[superwedge]

are there any tracking in or out for 350i,or is just set to a nom standard?

[mrzigazaga]

Hi Mate...I think this might help..



The tracking should be set at 3.2mm toe-in +/- 1.5mm

Caster: 3.5 - 4.0 deg. pos.
Camber (F) 1.0 deg. neg.
Camber (R) 1.0 - 1.5 deg. neg.
Toe (in) (F) 0.50 deg.
Toe (in) (R) 2MM - don't know why MM not deg!

2mm on 15inch rims = 0.30 degrees = 18 minutes
2mm on 17inch rims = 0.27 degrees = 16 minutes
Either way it's just a smidge toe in.

15 inch rims 3.2mm toe gives 0.24 degrees wheel to vehicle center-line or 0.48 degrees wheel to wheel.

14 inch rims 3.2mm toe gives 0.26 degrees wheel to vehicle center-line or 0.52 degrees wheel to wheel.

For the front
toe is 3.2 +/- 1.5mm
camber is 0 +/- 1.2 degres (not adjustable anyway is it?)
caster is 31.2 +/- 0.5 degrees
KPI 6 degrees (Not sure what this is?
For the rear
toe is 4.5mm
camber is 0.5 +/- 0.5 degrees (this seems small as the wheels have a visible camber)

Info supplied by a fellow wedger...Cheers...Ziga

[superwedge]

how does others set there tracking then? toe in or toe out?:rotate

[mrzigazaga]

Dave the answer is in the settings..I dont think you would want Toe out on a RWD car, Especially on the rear wheels???...Toe in keeps you straight...Ziga

[adam quantrill]

Toe in on the 350i when I could be bothered to set it up, as I recall it was 0-2mm so you could be parallel but a little in was better.