Like a watch, only bigger!
Like a watch, only bigger!
Author
Discussion

S6PNJ

Original Poster:

5,856 posts

312 months

Wednesday 31st July 2013
quotequote all
Well it being PH and all.....

I have recently inherited a Grand Father clock from my Grandfather who sadly passed away a few weeks ago. I now need to move it from his house to mine and was wondering if anyone had any good hints and tips for moving such a beast. I believe the clock comes apart in as much that the hood comes off the clock face and the clock mechanism is probably just suspended on the clock case. I'm also guessing the weights will just lift off their chains and that the pendulum will be removable. Other than lots of bubble wrap and care, is there anything else I should watch (geddit?) out for?

clockworks

7,813 posts

176 months

Wednesday 31st July 2013
quotequote all
First thing to do is wind it up so that the weights are near to the top of the door, but you can still see the pulleys.
Remove the hood.
Wrap some masking tape over the drums to hold the lines in place on the drums.
Unhook the weights from the pulleys.
Unhook the pendulum suspension spring from the back cock, and carefully feed it down through the crutch.
Lift the movement/dial/seatboard assembly off the case.

I never use packaging of any kind when transporting longcase clocks. Just put a towel on the back seat of your car, place the movement on the seat with the dial facing the backrest, and secure with seatbelt.
Make sure that the seatbelt doesn't snag the crutch, and the hands don't catch on the backrest.

Edit: the above assumes that it's an 8 day clock with 2 weights. If it's a 30 hour clock with one weight and a chain, just make sure that the chain doesn't slip off the sprockets - can be a pain to get back into place!

Edited by clockworks on Wednesday 31st July 08:16

Mastiff

2,515 posts

272 months

Wednesday 31st July 2013
quotequote all
I fking love this website sometimes.

Where else could you post such an off the wall question at 7.00am, and get a superb, concise and accurate response just over an hour later?

hehe

S6PNJ

Original Poster:

5,856 posts

312 months

Wednesday 31st July 2013
quotequote all
It's brilliant, isn't it! Thanks for a great reply. As far as I can recollect, it has 2 or 3 weights, not a single one. Cheers!

clockworks

7,813 posts

176 months

Wednesday 31st July 2013
quotequote all
If it's got 3 weights on chains, it's a modern(ish) German movement. No need to worry about taping things in place, but do make sure that you keep the movement upright. If the chains come off the sprockets, they can be a nightmare to refit!
If you are in any doubt, tie the 2 sides of each chain together, just below the seatboard. Use those wire ties from sandwich bags, or cable ties.

The problem with German "longcase" clocks is they can be a pain to take apart. Some don't even have removable hoods, you have to remove the hands and dial, then unscrew the movement from the seatboard.
Some of the earlier ones are easy, as the seatboard is fixed with thumbscrews, and the whole lot slides out the front.

If you can post some pics of the clock, I can probably help more.