Ignition problem - switch or barrel?
Discussion
My shed seems to have an intermittent starting problem - sometimes the key won't turn to the position that will start the engine therefore it won't start.
Is this likely to be a problem with the ignition switch itself (cheap) or the barrel (expensive due to the need to re-key etc) ? If it's the barrel I can just wire in a push button ignition switch that will start the engine when the ignition is turned on...
Is this likely to be a problem with the ignition switch itself (cheap) or the barrel (expensive due to the need to re-key etc) ? If it's the barrel I can just wire in a push button ignition switch that will start the engine when the ignition is turned on...
Had a similar problem with my accord. Took the barrel off and took it to local timpsons he looked at it told me it was worn. Threw some graphite powder down it and its been bang on everytime.
Saved me a fortune as new barrel would have had new key. Which would have needed coding in to the immobiliser.
Cost was £20 for his time and help
Toaster Pilot said:
Never have trouble turning the key to the position that puts all the warning lights on etc so I assume (perhaps wrongly) that the key itself is fine.
Invalid assumption. I had exactly the same issue on a completely different car. It would go to the accessory position without issue, but wouldn't turn any further because of wear on the key. There was no sign of damage to the barrel and a new key cut to code solved the problem.
Gassing Station | General Gassing | Top of Page | What's New | My Stuff



