ID coolant hoses (heater) bracket?

[996TT02]

There is a support bracket attached to the RHS of the tranny/diff (rear), attached just by the RHS inner CV joint. It's for narrow gauge coolant hoses, must be for heating hoses. It's very rusty and needs replacing, but on Porsche's parts list "Katalog" there is nothing that looks quite like it.

Katalog depicts Tip brackets with the indication that the image does not represent the 6-sp item. So I'm stuck

It could be 99610652672. But I have no way of telling. All images online point to the same Porsche drawings, so not much help there!

In the pics, it's the rusty part, with the "fork" slot to prevent rotation while doing up the retaining bolt.

Any ideas? Thanks in advance...

[NBTBRV8]

Could it be 996 106 536 71?

Looking at how rusty they all are, I'd just replace the lot.

[996TT02]

NBTBRV8 said:

Could it be 996 106 536 71?

Looking at how rusty they all are, I'd just replace the lot.

Had looked at that but discounted, on the basis that from the diagram it would appear that those clamps that attach to it, are for metal pipes not rubber. I think...

Either way it's not the same as in the diagram, in effect the part I need is more "U" shaped.

Grrrr...!!

[cd1957]

Hi just had a look on PET for Turbo 2001-2005.
If you go to section 105-03,main bracket is number 12,with the two clamps being 15 and 24,make sure you pick the correct ones for your gearbox

Chris in Cardiff

[996TT02]

cd1957 said:

Hi just had a look on PET for Turbo 2001-2005.
If you go to section 105-03,main bracket is number 12,with the two clamps being 15 and 24,make sure you pick the correct ones for your gearbox

Chris in Cardiff

Hi Chris,

Thanks, that's the one I suspected but perhaps because it's for the Tip in the pic, it looks different. Then again the angle is odd and what I can actually see is also not much, either.

I will probably buy this part (and the clips) as I can see no other likely candidate.

Thanks again!